#1
IP: 71.113.184.227
|
|||
|
|||
NEW VIDEO - Head Removal
|
#2
IP: 32.211.28.40
|
||||
|
||||
Nice video. Well done.
My only suggestion would be to loosely replace the nuts after doing the wire brushing. This will allow you to tap on the nut and not damage the threads on the top of the stud. |
#3
IP: 38.27.109.137
|
|||
|
|||
I think I would have left the plugs in the holes while doing the wire brushing, to keep the debris from falling into the holes.
Bill |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Broken head stud in the block - removal advice | PassionOne | Overhaul | 15 | 11-11-2015 06:43 PM |
Head Removal Due to Power Loss | Bruce A | Troubleshooting | 58 | 07-18-2012 11:10 AM |
Head Removal Tool | Hughes35 | Overhaul | 24 | 04-19-2011 04:44 PM |
A4 Cylinder Head Removal | doralda | General Maintenance | 0 | 05-06-2007 12:26 AM |
Removal of the cylinder head studs | Unregistered | General Maintenance | 1 | 12-18-2005 12:34 PM |