#1
IP: 72.143.212.109
|
||||
|
||||
Vibrations when in gear
Hello everyone, the boat is finally in the water, everything is fine with the engine in neutral.
But when I put it in gear it has a bad vibration. Not sure where it comes from and getting down to the shaft, well you know how much space there is down there. Mine is the direct drive with reversing gear Thank you in advance Fred |
#2
IP: 162.245.50.136
|
|||
|
|||
Check to see if something got wrapped around the prop. If nothing is on the prop the shaft may be bent. You should be able to see the wobble while looking at the packing gland inside the boat if the shaft is bent. it could even be the engine missing while under the load of being in gear.
Is the vibration the same in forward and reverse? Dave Neptune |
The Following User Says Thank You to Dave Neptune For This Useful Post: | ||
Sam (06-06-2023) |
#3
IP: 184.74.10.106
|
||||
|
||||
I also suspect bent shaft.
Any chance the straps were under the shaft the last time you were hauled? If the bend turns out to be between the strut bearing and the hull, you know where the blame lies. |
#4
IP: 70.66.128.205
|
||||
|
||||
Could it be a possibility that the hull shape changed while the boat was out of the water causing the shaft to be out of alignment. I would think this would be a small chance but it can happen. Might just need some time in the water to get it's form back. Either way, check the alignment.
__________________
Chuck 71 Ranger 29 |
#5
IP: 72.143.213.49
|
||||
|
||||
So I motored a bit, does not vibrate when in reverse.
Only a bit in forward |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
idler gear conundrum | azazzera | Overhaul | 2 | 07-02-2015 08:33 PM |
Forward and Reverse Gear Adjustment Issues | CraigRun | Reversing Gear | 12 | 05-17-2012 09:15 PM |
Reverse gear overheat?? | NorfolkRagbagger | Reversing Gear | 5 | 10-13-2010 09:20 AM |
Replacing gaskets on reversing gear and reduction gear housings | phorvati | Troubleshooting | 1 | 10-06-2008 02:10 PM |