My old Morse shift/throttle levers are located in the cockpit where people (ok, I) have a tendency to accidentally kick them, step on them, etc. Quite often, this results in the throttle cable wire pulling out of the little barrel/screw fitting on the carburetor.
So I have two queries:
1-Is there a better way to fasten the cable to the carburetor?
2-Does anyone have any experience or recommendations for upgrading their control mechanism?
Thanks!
So I have two queries:
1-Is there a better way to fasten the cable to the carburetor?
2-Does anyone have any experience or recommendations for upgrading their control mechanism?
Thanks!
Comment