Return to the home page...

Go Back   Moyer Marine Atomic 4 Community - Home of the Afourians > Discussion Topics > Ignition System

Reply
 
Thread Tools Display Modes
  #1   IP: 192.136.164.148
Old 10-04-2021, 02:56 PM
jim.facey@gmail.com jim.facey@gmail.com is offline
Frequent Contributor
 
Join Date: Jul 2019
Posts: 8
Thanks: 0
Thanked 1 Time in 1 Post
Distributor stuck, canít remove it

I am in the process of installing a new water jacket side plate, and had to put in repair studs in most of thee holes. Now in order to slide the plate onto the studs, I need to remove the distributor (for one minute) because the two studs at the very back of the plate are two close to the distributor to slide the plate over them. I disconnected the two incoming wires, removed the distributor cap and hold down bracket, but the distributor does not budge. I can rotate it slightly with great force but am afraid of forcing anything. I have bathed it in kroil oil and tapped on it but no joy. I had the thing out a couple of years ago for some trouble shooting and all has been well, except for the leaky water jacket.

Any ideas or suggestions will be greatly appreciated.

Jim
Reply With Quote
The Following User Says Thank You to jim.facey@gmail.com For This Useful Post:
TimBSmith (10-05-2021)
  #2   IP: 165.225.20.159
Old 10-04-2021, 04:44 PM
Surcouf's Avatar
Surcouf Surcouf is online now
Afourian MVP, Professor Emeritus
 
Join Date: May 2018
Posts: 327
Thanks: 270
Thanked 135 Times in 104 Posts
more penetrant, more patience, and not too much brut force...
Try a mix of ATF and Kroll, spray at the top everyday, with sligt taps up and down and use any available rotation... and repeat.

When I removed mine, it was frozen in place, I then had to destroy whatever was left inside with hammer and scewdrivers... it was not pretty
But if the "finger" moves, even slightly, there is hope.
__________________
Surcouf
A nostalgic PO - Previously "Almost There" - Catalina 27 (1979)
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Removal of Prop Coupling - To Remove Engine ajgaines Overhaul 10 09-03-2019 11:34 AM
How to remove side plate bolts w/o breakage ArtJ Cooling System 4 08-26-2010 08:01 PM
Can't remove old alternator belt m_galligan General Maintenance 15 10-06-2008 08:52 PM
Removing the engine from your boat Don Moyer Ranger 7 12-12-2005 12:24 PM
Hoses hard to remove HOTFLASH Cooling System 0 11-11-2005 01:22 PM


All times are GMT -4. The time now is 07:08 AM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2021, vBulletin Solutions, Inc.


Universalģ is a registered trademark of Westerbeke Corporation

Copyright © 2004-2021 Moyer Marine Inc.

All Rights Reserved