#76
IP: 98.225.57.144
|
||||
|
||||
When rebuilding an engine you measure the cyl bores near the top and near the bottom. Measure twice at both ends 90 degrees from each other. That is north and south and then east and west both about an inch from the top and bottom. Doing so will give you the taper, the average cyl wear, and the ovality or out of roundness. Out of roundness will cause oil burning, blow by and loose of compression.
__________________
Mark C30 "Kismet" |
Tags |
lifters, sticky, stuck, valve |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Valve Lifters NOT Moving | keithems | Troubleshooting | 47 | 07-21-2011 07:39 AM |
Valve Spring Job Done! | rpowers | General Maintenance | 13 | 01-18-2011 02:29 PM |
valve removal | JarrettF | Overhaul | 5 | 05-26-2008 09:03 PM |
Broken valve stem stuck in the valve guide | Unregistered | General Maintenance | 1 | 11-19-2005 08:26 AM |