#26
IP: 104.174.83.118
|
||||
|
||||
I thought you might have. It's correct for measuring coil resistance (wires removed as you said) but not voltage. Despite how it is identified, the small coil '-' post is not a ground.
Run the calculation again with the new voltage measurement. Voltage is expected to be in the range of 13~14 volts. I expect the end result to be the same, "resistor not required."
__________________
Neil 1977 Catalina 30 San Pedro, California prior boats 1987 Westsail 32, 1970 Catalina 22 Had my hands in a few others |
#27
IP: 72.218.38.55
|
||||
|
||||
Neil the Atomic 4 Whisperer:
Voltage at the coil [ + ] terminal at cruising RPM 13.5 Volts Primary winding resistance of the coil 3.9 Ohms (terminal to terminal, [ - ] wire removed) Recommended resistor 0.1 Ohms Major feeling of confidence. Thank you
__________________
Bill McLean '76 Ericson 27 :valhalla: Norfolk, VA |
#28
IP: 104.174.83.118
|
||||
|
||||
Bill, I wouldn't fuss with an added resistor if I were you.
Respecting good engineering practice, the calculator adds a 15% margin of safety below 4 amps (3.4 amps target) and your setup calculates to 3.46 amps. You're good right where you are.
__________________
Neil 1977 Catalina 30 San Pedro, California prior boats 1987 Westsail 32, 1970 Catalina 22 Had my hands in a few others |
#29
IP: 72.218.38.55
|
||||
|
||||
Thank you Neil. I was thinking the same thing. Gee wiz a tenth of an ohm? What's that like? a breath of warm air vs. cold air?
This E ignition comes from Indigo and has a resistor strapped to the coil. All PO stuff. Tom was saying it should be OK. Now I know it is OK.
__________________
Bill McLean '76 Ericson 27 :valhalla: Norfolk, VA |
#30
IP: 104.174.83.118
|
||||
|
||||
In that case I defer to Indigo Electronics. It's best that they specify the recommended amperage for their product. The advice and calculator I provided here pertain to the EI product Moyer Marine offers following the manufacturer's published advisement and our testing. Indigo may choose to follow the same specification but that is for them to say.
__________________
Neil 1977 Catalina 30 San Pedro, California prior boats 1987 Westsail 32, 1970 Catalina 22 Had my hands in a few others |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wiring clean-up [long message alert] | Esgbradford | Electrical | 11 | 02-03-2014 12:49 AM |
How to use terminal blocks on wiring harness? | JonnyQuest | Electrical | 8 | 12-02-2013 04:43 PM |
wiring for fuel pump | Mark Jones | Catalina | 11 | 08-27-2010 07:35 PM |
Wiring Harness | gpd955 | Catalina | 5 | 07-27-2010 07:23 PM |
Looking for wiring help | Bob Nash | Electrical | 5 | 06-20-2008 04:29 PM |