I am swapping out an old model A4 with a new model A4. The bores on the old model are smaller than the new model. Can anyone tell me if the locations will be the same? Can I just supersize the mounting studs and be confident that the new engine will be located exactly the same as the old one?
Any reccomended sizes for the stud/bolt diameter for the new model. Do I want something that gives me a little wiggle room, or do we want something that's a close fit?
Anyone ever have to do the same procedure?
Any reccomended sizes for the stud/bolt diameter for the new model. Do I want something that gives me a little wiggle room, or do we want something that's a close fit?
Anyone ever have to do the same procedure?
Comment