#1
IP: 24.193.42.223
|
|||
|
|||
Looking for cheap tach to set idle
I need to reset my idle after adjusting a number of things and I want to get the RPMs set correctly but I have no gauge installed. Is there a cheap version that I can temporarily connect to the coil just for setting the idle speed?
|
#2
IP: 71.252.15.151
|
||||
|
||||
Sure...pick up any tach at the local auto store. I bought (and currently still have installed) a Sunpro for about $30.
It is not as good a gauge as the type Moyer sells, but you can still read it and discern engine within about 50 RPM intervals.
__________________
-Shawn "Holiday" - '89 Alura 35 #109 "Twice Around" - '77 C-30, #511 with original A-4 & MMI manifold - SOLD! (no longer a two boat owner!!) |
#3
IP: 173.166.26.241
|
||||
|
||||
JC Whitney has a dwell/tach/volt analyzer for $40.
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Erratic Engine Speed | Unregistered | Troubleshooting | 3 | 01-24-2012 10:12 PM |
Suspected Idle Circuit Blockage - causing idle problems | dman535 | Fuel System | 15 | 07-19-2009 07:49 AM |
Puzzling behavior after carb adjustment | Baltimore Sailor | Fuel System | 22 | 06-11-2009 10:44 AM |
Idle mix too lean? | Sailormike | Troubleshooting | 7 | 11-06-2006 07:23 AM |
Idle RPM | tartan30cirrus | General Maintenance | 6 | 05-17-2005 06:58 PM |