Return to the home page...

Go Back   Moyer Marine Atomic 4 Community - Home of the Afourians > Discussion Topics > Exhaust System

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #1   IP: 76.238.136.44
Old 04-07-2010, 11:39 PM
Triton106 Triton106 is offline
Senior Member
 
Join Date: Jan 2009
Posts: 73
Thanks: 0
Thanked 2 Times in 2 Posts
Exhaust Hot Section On Pearson Triton

Keelcooler in response to a picture of my engine room from another thread asked that I post the details of the hot section design. I inhereted it from the PO who had it custom built by a reputable boat yard Richmond Boat Works (now KKMI) of stainless steel (see picture below). The design is a custom fit for the Pearson Triton engine room (see picture below). The hot section bends from the manifold flange back toward the cabin and then rises up about 12 inches after clearing the bulkhead under the bridge deck. The cooling water is then injected into the hot section on the way down. I recently moved the waterlift muffler to under the port cockpit to make room for the new fuel tank (see picture). This raised the static height of the waterlift muffler a few inches. It's good thing that the rise in the hot section is sufficient to allow 12" of height difference between the waterlift muffler and the highest point of the hot section. I am very pleased with the quality and design of the hot section.

The stainless steel hot section



Blossom's (Triton) engine room



New location for the waterlift muffler



Ray
Blossom - Triton 106
Alameda, California
Reply With Quote
The Following User Says Thank You to Triton106 For This Useful Post:
TimBSmith (10-09-2020)
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Replacing hot section of T30 Exhaust BadaBing Exhaust System 16 01-17-2015 06:29 PM
New exhaust system jsedivy Exhaust System 11 08-01-2011 07:50 PM
Joint compound for exhaust hot section replacement ddomino Exhaust System 7 01-17-2009 07:18 AM
exhaust hot section restoration harvey Exhaust System 4 09-11-2007 04:42 PM
Flexible hot section for exhaust Kelly Exhaust System 7 08-21-2007 05:12 AM


All times are GMT -4. The time now is 09:03 AM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.


Universal® is a registered trademark of Westerbeke Corporation

Copyright © 2004-2024 Moyer Marine Inc.

All Rights Reserved