Return to the home page...

Go Back   Moyer Marine Atomic 4 Community - Home of the Afourians > Discussion Topics > Fuel System

Reply
 
Thread Tools Display Modes
  #1   IP: 107.77.228.86
Old 11-29-2021, 02:15 PM
ColeHarmening's Avatar
ColeHarmening ColeHarmening is offline
Senior Member
 
Join Date: Apr 2020
Location: Oceanside
Posts: 17
Thanks: 5
Thanked 6 Times in 5 Posts
Fuel Pump PSI

Welp after several weeks of intermittent shutdowns from fuel related problems. I finally found that my recently purchased facet E - fuel pump from Moyer marine had a factory loose + wire coming out of the pump cylinder. This was causing the fuel pump to intermittently shutoff when the boat started moving. I slapped in the spare fuel pump bought by a Previous owner and now the engine does not have the intermittent shutdowns. But it is pushing anywhere from 5 - 7psi to my carb. The PO must have not purchased their pump from moyermarine. As measured by my fuel pressure gauge. How dangerous is pushing 4 more psi than the recommended 3psi? Ordering a new fuel pump today but would like to know if I can run the engine in the meantime?
Reply With Quote
  #2   IP: 138.207.177.95
Old 11-29-2021, 03:01 PM
joe_db's Avatar
joe_db joe_db is online now
Afourian MVP
 
Join Date: May 2009
Posts: 4,134
Thanks: 49
Thanked 789 Times in 572 Posts
Not 100% sure...........
My pump runs right at 4.8 and I do not have any issues at all. Ages ago I had a 10 PSI pump and regulator and could tell no difference between 1 PSI and 9 PSI. That said, I would be a bit worried about leakage past the needle valve, especially at low speeds. If it were me, I would find a pump in the 3-5 PSI range for peace of mind. Meanwhile, if the engine starts to bog at low throttle settings that will be a sign you are getting too much gas. Our carbs really are not demanding for pressure, we use maybe a gallon an hour at most.
Reply With Quote
  #3   IP: 47.142.140.12
Old 11-29-2021, 05:44 PM
JOHN COOKSON JOHN COOKSON is offline
Afourian MVP, Professor Emeritus
 
Join Date: Nov 2008
Posts: 3,500
Thanks: 54
Thanked 848 Times in 623 Posts
Try asking Ken @ MMI when you return the pump. He knows a lot of A4 related stuff - he might know the answer to your question. No harm in trying.

ex TRUE GRIT
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Fuel Pump Troubleshooting Question sdemore Fuel System 7 08-13-2018 07:39 AM
Fuel pump question ... Robs Hubris Fuel System 49 06-20-2018 02:51 PM
Shutdowns: Fuel Pump? JOHN COOKSON Fuel System 7 04-19-2016 11:09 AM
Engine runs for a couple minutes, stops hard, no fuel flow pdecker Troubleshooting 30 05-28-2015 01:17 PM
Mechanical fuel pump rebuild services Don Moyer Fuel System 40 01-14-2013 11:17 AM


All times are GMT -4. The time now is 11:13 AM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2022, vBulletin Solutions, Inc.


Universal® is a registered trademark of Westerbeke Corporation

Copyright © 2004-2022 Moyer Marine Inc.

All Rights Reserved