#1
IP: 24.61.95.61
|
|||
|
|||
Ignitor core orientation
I just removed the ignitor round magnetic core "on my delco distributor in
order to lube the flywheel weight mechanism underneath the plate When I went to reinstall the core I discovered that it could slide on in 2 different positions 180 degrees apart. I Checked my installation instructions and it only mentions fully seating it below the rotor around 1/2 inch and nothing about which position it belongs in of the 2 180 degrees apart Does it matter which of the 2 positions it is installed in? Thanks Art |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Cooling water intake - orientation | ecumming | Cooling System | 3 | 11-10-2016 06:27 AM |
MMI 502 flange pump seal orientation. | Joel H. | Cooling System | 5 | 04-05-2015 08:47 PM |
Choke orientation | taylor | Fuel System | 16 | 03-09-2014 09:01 PM |
Mystery Distributor Plate Orientation | fvigeant | Ignition System | 10 | 07-07-2010 11:16 PM |
Fuel pump orientation | dman535 | Fuel System | 1 | 06-19-2009 02:30 PM |