|
Very cool. Thanks Dave.
Yeah. I did post twice. This is my fist time posting on any type of forum and I wanted to be sure I was posting to the correct place.
I think i understand a bit better.
The acid flush is usually to correct a problem, as opposed to it being for maintenance.
Cool.
I will do the Fresh water flush since you stated that it helps to de-salt.
Yeah. I'm just trying to be proactive and keep my engine happy.
For the Vinegar flush; if i put a solution in a bucket and an intake into the bucket. How do I "let it sit in the engine for a few hours"?
Start the engine and then stop it, half way through the bucket?
Now the vinegar solution is in the system until I run fresh or Salt water again?
Or is there some way to close the system and trap the solution in there? and then open again to discharge?
I will do the fresh water flush today. Im looking forward to it. (small victories).
What ratio of vinegar to water should I use?
Thanks again everybody
|