Thermostat housing stud length 3 1/4 too short
The left hand thermostat stud (end closest to lifting eye) is
3 1/4 inches long .
While installing this stud found it would not really tighten until
in so far that only a couple of threads show above the housing
If I really torqued it in I could probably make it flush on housing.
Why does this one go in so far? f I get a 3/1/2 stud and use it
will it do damage to the block?
The alternative is to not iinstall the stud so deep
What is the best thing to do?
Thanks Appreciated Art
|