View Single Post
  #14   IP: 100.40.58.241
Old 10-21-2020, 09:39 AM
jcwright jcwright is offline
Afourian MVP
 
Join Date: Jul 2012
Posts: 158
Thanks: 5
Thanked 99 Times in 75 Posts
Hello again Greg.

Yes, I was referring to the smaller hole, not the one for the stud.

I also checked the parts manual last night. I wasn't able to find the set screws either on the page that shows the spindle or anywhere else. This reminds me of a much earlier post by Don Moyer where he describes the set screws as a 'booby trap'.

The only other suggestions that come to mind are to get plenty of light down that hole and if necessary clean it out.

Best of luck.

J.
Reply With Quote