View Single Post
  #2   IP: 209.52.88.194
Old 10-10-2020, 07:43 PM
MarkVon's Avatar
MarkVon MarkVon is offline
Senior Member
 
Join Date: Apr 2020
Posts: 22
Thanks: 8
Thanked 3 Times in 3 Posts
I just clamped off the two hoses connected to the pump and removed the cover. Cover seems fine. Rubber ring seems fine. There isn’t a gasket though...

I put a small amount of permatex gasket maker around inside edge of the plate and put it back on. I removed the clamps and it’s still dripping..

Here’s a video from underneath showing the leak and below is a wider picture:

https://youtu.be/cT2S3PpGIs8 (the sound is the bilge blower, not the engine)

The drip seems to be forming from further back on the pump, rather then the pump plate. Any thought/tips appreciated!
Attached Images
 

Last edited by MarkVon; 10-10-2020 at 08:13 PM.
Reply With Quote