View Single Post
  #24   IP: 47.142.131.74
Old 07-03-2021, 09:04 PM
JOHN COOKSON JOHN COOKSON is offline
Afourian MVP, Professor Emeritus
 
Join Date: Nov 2008
Posts: 3,500
Thanks: 54
Thanked 855 Times in 629 Posts
Quote:
Originally Posted by Ando View Post

In the meantime, since there’s probably no way for me to peer into the port itself to see if it is beveled correctly as per the instructions, the question is: Does the seating tool need to be rotated until the face of it is flush with the face of the port to which it slides into? I ask because I have applied pressure and turned and turned and turned (all the while cleaning the bit and reapplying lithium paste to the bit) and come to a place where it doesn’t seem to be meeting resistance and the rotator is about a quarter to one half inch away from the face of the port. Should I keep beveling until it is flush?
If you don't get an answer from a forum member R\E this, call Ken at MMI.

ex TRUE GRIT
Reply With Quote
The Following User Says Thank You to JOHN COOKSON For This Useful Post:
Ando (07-03-2021)