Quote:
Originally Posted by Don Moyer
Hi Greg,
Hopefully you didn't tighten the inside part of the puller too tightly, in which case you should be able to wrap some protective material around the spindle and hold it gently with a pair of vise grips. Thin cardboard, like a piece of file folder material should work. I always held the spindle on the smaller end that goes into the block so that if I ended up with any dings I could take a small file and dress that area up a bit. Don
|
Well I thought I put it on only finger tight.. but my assumption is the screwing down the outside section tightened the inside part.
I'll try the carboard on the THIN section tonight.
Note: upon reflection - I did not hold the inner screw steady with a wrench while screwing down the outside section- so it tightened it down the inner screw way too much.