View Single Post
  #4   IP: 32.211.28.40
Old 02-06-2017, 11:00 PM
Al Schober's Avatar
Al Schober Al Schober is offline
Afourian MVP
 
Join Date: Jul 2009
Location: Uncasville, CT
Posts: 2,002
Thanks: 16
Thanked 578 Times in 405 Posts
The tranny shaft needs a certain amount of angular rotation to go into fwd/rev properly. The longer the shift arm is, the lower the forces will be but the higher the amount of cable travel needed. The standard shift cable will only give you 4" of travel (if I remember correctly).
Someone must know the correct arm length to use the 4" of travel. Anyone? I admit I'm a bit embarrassed that I don't know..
Reply With Quote