View Single Post
  #2   IP: 68.4.186.79
Old 10-25-2013, 04:50 PM
yeahjohn yeahjohn is offline
Senior Member
 
Join Date: Jun 2012
Posts: 261
Thanks: 0
Thanked 6 Times in 5 Posts
I'll try to help as best as possible. You will need to pull your reversing gear completely out to remove the tail shaft. That means removing the entire rear housing. The hardest part of the job is pressing the cupling on after taking it off. It seems you are going down the right path, just plan on removing the entire rear housing and pulling the reversing gear to inspect it and fix as needed. I think we must be getting to a critical time in the reversing gear life cycle. I have seen tons of these post as of late.
Reply With Quote
The Following User Says Thank You to yeahjohn For This Useful Post:
TimBSmith (05-10-2022)