Quote:
Originally Posted by 67c&ccorv
What kind of fitting do you use on the end of that 8 AWG wire that connects to the ignition switch? I am using a brand new Cole-Hersee ignition on/off switch with a new starter button to turn the motor over. The connections use #8 screws - even the smallest terminal fitting that will go over an 8 AWG wire will probably slip right over the #8 screw fitting on the starter switch. Any thoughts?
|
I did a google search on "AWG 8 ring terminal #8" and found this
http://www.doityourself.com/invt/u514925, but that's just an example. There should be a variety of options. Look for a good quality copper ring terminal, ideally with a built-in heat shrink/adhesive sleeve to make a nice "marine" terminal after making a proper crimp. See
http://www.pbase.com/mainecruising/wire_termination.