Thanks. I will try to find the pins. I cannot find them on Dons' picture but as I get started, I am sure they will become obvious.
Can they be driven out from the front toward the rear of the housing?
Don did suggest leaving the pins out when reassembling - until the housing is lined up and in place. Is that what you were referring to?
Thanks again for the help, all. I am becoming quite knowledgeable before I even get my hands dirty. I overhauled this engine in my basement in 1997 - and it was slipping just a bit then. Wish I had done something about it then. Also, I should remember where those pins are. G------------------
|