View Single Post
  #31   IP: 76.237.153.161
Old 09-16-2020, 05:51 PM
brewgyver brewgyver is offline
Senior Member
 
Join Date: Jun 2014
Posts: 43
Thanks: 4
Thanked 8 Times in 7 Posts
If you have to remove a machine screw that's really tight: Carefully seat the driver on the screw heat (always use a drive that fits!), then give the end of the driver a couple of whacks with a mallet or hammer, or field expedient (wrench, channel locks, etc.) This will often do the trick.
Reply With Quote
The Following 2 Users Say Thank You to brewgyver For This Useful Post:
Ando (09-16-2020), W2ET (09-16-2020)