View Single Post
  #15   IP: 72.94.92.192
Old 04-20-2022, 12:15 PM
SbMolly SbMolly is offline
Senior Member
 
Join Date: Jul 2021
Posts: 14
Thanks: 9
Thanked 5 Times in 4 Posts
My existing one has not failed yet - but I just dropped a replacement motor in, and since the exhaust looked a little rough, wanted to replace that while everything was apart.

Moving the Moyer water injection fitting down a few inches is my last step - intend to put a 2 inch straight piece between that piece, and the last 90 degree bend.

Can’t decide if i should look around for a plumbing supply store, and replace two of the bends with the proper parts, or go with the Mega low-mart all female bends, and couplers. Leaning towards a shopping trip, just need to find the time.
Reply With Quote