View Single Post
  #13   IP: 45.148.7.7
Old 05-30-2021, 07:52 AM
campbdon campbdon is offline
Senior Member
 
Join Date: May 2021
Posts: 45
Thanks: 16
Thanked 6 Times in 5 Posts
Order of Devices...

It is a box of sheet metal construction that fits snugly over the flame arrestor (a brass (I think) porous grid "filter" thingy) and (above that) a foam sponge (replacing the original which eventually disintegrated). The arrestor is at the bottom with the sponge above it so the sponge is what's visible when the whole thing is viewed from above. Everything fits tightly with no play and air can definitely pass through it all without problem. I'd have to go back to the boat to verify what makes the cover look like that, but it has been used without problems by myself and the PO (11 yrs ago). The assembly is screwed down onto the carb throat with 2 screws. Does this make sense?
Thanks
DC
Reply With Quote