I put the kit in several years ago and it’s worked flawlessly. However today while on the hard and working on the fuel pump (another thread) I went to start it and no spark. We had pulled the coil wire to make sure it wouldn’t start while checking the fuel pump drive shaft.
Checked all the connections and found spark to the distributor but nothing at the plugs. After poking around and a little tap on the EI module, it came back to life.
Anyone have this happen? It’s working fine but a little nervous it will do it again at a less convenient time.
Thanks in advance.
Checked all the connections and found spark to the distributor but nothing at the plugs. After poking around and a little tap on the EI module, it came back to life.
Anyone have this happen? It’s working fine but a little nervous it will do it again at a less convenient time.
Thanks in advance.
Comment