View Single Post
  #6   IP:
Old 06-08-2022, 09:46 PM
jcwright jcwright is offline
Afourian MVP
Join Date: Jul 2012
Posts: 158
Thanks: 5
Thanked 98 Times in 75 Posts
For removing the coupler bolts, the suggestion I found helpful is in post #9 in this thread:

I believe one of your earlier suggestions is referring to adjusting the valve clearances. This does not require removing the head. The cover that gives you access to the tappets is on the carburetor side of the engine.

Reply With Quote
The Following User Says Thank You to jcwright For This Useful Post:
68PearsonRenegade (06-08-2022)