Hi Dutton. Thanks for yuor response. I think I did mention it though. I said the position-1 on the distributor, which I take it you're calling position-1 on the rotor, currently goes to the number-4 cylinder. So, if I understand, all I need do is move that wire to the number-1 cylinder at TDC and then move all the other wires to their correct cylinder without changing any of the positions on the rotor. I'd have rotor-1 goes to cylinder-1, rotor-2 to cylinder-2, rotor-3 to cylinder-4 and rotor-4 to cylinder-3. Do I understand correctly?
|