View Single Post
  #5   IP: 71.118.13.238
Old 07-25-2017, 06:11 PM
Dave Neptune Dave Neptune is offline
Afourian MVP, Professor Emeritus
 
Join Date: Jan 2007
Location: Grove, Oklahoma
Posts: 5,035
Thanks: 711
Thanked 1,289 Times in 839 Posts
Jim, the sanding dust could easily plug up an idle passage or an idle jet. If you do not get any response from the idle air adjusting screw, get the idle passages blown clear for sure. The idle jet is around .018", very small. You could of blown other KRUD into them by not removing them.

Dave Neptune
Reply With Quote