View Single Post
  #17   IP: 99.30.185.198
Old 06-24-2019, 08:44 PM
thatch thatch is offline
Afourian MVP
 
Join Date: Dec 2009
Location: Santa clarita, Ca.
Posts: 1,079
Thanks: 235
Thanked 257 Times in 138 Posts
Since you have the forward clutch pack now working, the next step I would take would be to align the tab on the brake band reversing bar into it's intended hole and tighten the reversing band adjustment nut until the band is snug around the clutch pack drum. If the 1/2"od roller is still in place the reversing bar should now be resting flat against the side of the reverse band brace. If all of the parts now line up correctly, you should then loosen the large adjustment nut just far enough to allow the forward drum to turn freely. At this point the final adjustments for forward and reverse should be made in small increments.
Tom
Reply With Quote
The Following 2 Users Say Thank You to thatch For This Useful Post:
Administrator (06-24-2019), TimBSmith (09-22-2020)