Return to the home page...

Go Back   Moyer Marine Atomic 4 Community - Home of the Afourians > Search Forums

Showing results 1 to 9 of 9
Search took 0.01 seconds.
Search: Posts Made By: slunga
Forum: Troubleshooting 10-31-2009, 12:34 PM
Replies: 8
Views: 3,288
Posted By slunga
Thanks for all of your replies. I guess I have my...

Thanks for all of your replies. I guess I have my weekend cut out for me. I'll report back after I see what's going on. thanks again.
Forum: Troubleshooting 10-31-2009, 11:50 AM
Replies: 8
Views: 3,288
Posted By slunga
Don, the three galley plugs were installed and...

Don, the three galley plugs were installed and the idler gear shaft was left in place and set screws were not removed. I'm at a loss. I guess it's time to disassemble.
Forum: Troubleshooting 10-31-2009, 11:02 AM
Replies: 8
Views: 3,288
Posted By slunga
No Oil Pressure

Dan, the pump was cleaned when the old elbow was taken out. I cranked the motor for about a total of 4-5 minutes, 30-60 seconds at a time. I really hate the thought of taking everything apart again....
Forum: Troubleshooting 10-31-2009, 08:45 AM
Replies: 8
Views: 3,288
Posted By slunga
No Oil Pressure

After a total rebuild and double checking all the steps, I can't get any oil pressure when I bench tested. Five and 1/2 quarts in the pan, all journal plugs in, new screen elbow and just a trickle of...
Forum: Troubleshooting 10-27-2008, 10:16 AM
Replies: 7
Views: 5,341
Posted By slunga
Don, you were right again. I went down to the...

Don, you were right again. I went down to the boat Sunday and removed the main passage plug and main jet. Some flecks of crud came out and the jet was partially clogged. I carb cleaned all the...
Forum: Troubleshooting 10-20-2008, 10:36 AM
Replies: 7
Views: 5,341
Posted By slunga
Went down to the boat Sunday and put new fuel in...

Went down to the boat Sunday and put new fuel in the new tank and fired up the A4. It ran perfect for about 15 minutes, then the rpms started to drop. then the engine started to"lope", going from low...
Forum: Troubleshooting 10-06-2008, 05:27 PM
Replies: 7
Views: 5,341
Posted By slunga
Don, I think I may have found the problem(s) with...

Don, I think I may have found the problem(s) with the rough running a-4. I decided to pump out all the gas in the tank and inspect. The gas was ok but there was some "stuff" floating around in the...
Forum: Troubleshooting 09-08-2008, 02:33 PM
Replies: 7
Views: 5,341
Posted By slunga
Now Running Rough

Brought the boat back to the dock under power and engine had run fine all day. A strong wind was coming from astern so I put it in reverse to slow it down a little. It popped out of reverse and the...
Forum: General Maintenance 11-20-2006, 02:18 PM
Replies: 112
Views: 168,600
Posted By slunga
antifreeze in the block

Is it possible to remove the rear block drain plug and the thermostat housing and pour antifreeze directly into the block until it comes out the plug and then retighten? Just a thought.
Showing results 1 to 9 of 9

 
Forum Jump

All times are GMT -4. The time now is 11:02 AM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.


Universal® is a registered trademark of Westerbeke Corporation

Copyright © 2004-2024 Moyer Marine Inc.

All Rights Reserved