Return to the home page...

Go Back   Moyer Marine Atomic 4 Community - Home of the Afourians > Search Forums

Showing results 1 to 16 of 16
Search took 0.01 seconds.
Search: Posts Made By: Jeff in TO
Forum: Troubleshooting 08-04-2014, 09:06 PM
Replies: 38
Views: 13,902
Posted By Jeff in TO
Thx for the thoughts - this is my friend's boat...

Thx for the thoughts - this is my friend's boat and I didn't install the EI.

IF the ring could move down the shaft slightly further it would solve the issue for sure - I do not think it's a bad...
Forum: Troubleshooting 08-04-2014, 09:02 PM
Replies: 27
Views: 8,536
Posted By Jeff in TO
On the box, it's clearly labelled "professional...

On the box, it's clearly labelled "professional quality automotive parts"

I think it's perfectly fine - not a concern about the quality. The contact points appear to be brass (yellow metal).
...
Forum: Troubleshooting 08-02-2014, 08:04 AM
Replies: 27
Views: 8,536
Posted By Jeff in TO
Dave, a comment on your post above. I just...

Dave, a comment on your post above. I just bought a new cap from Moyer, received it yesterday. It's in an AUTOMOTIVE box. Not disputing the quality, as well as supporting this amazing community -...
Forum: Troubleshooting 08-02-2014, 07:53 AM
Replies: 38
Views: 13,902
Posted By Jeff in TO
So, just to close the loop. coil, cap,...

So, just to close the loop.

coil, cap, rotor, wires, all replaced.

Runs great. We ran at the dock for about 1h 20min and we felt satisfied we have restored reliability.

Thanks to...
Forum: Troubleshooting 07-23-2014, 10:54 AM
Replies: 38
Views: 13,902
Posted By Jeff in TO
For sure - I will do! Also, so far not one...

For sure - I will do!

Also, so far not one of those who responded has commented on my question in the initial post re: the electronic ignition - should anyone have thoughts about this I would...
Forum: Troubleshooting 07-23-2014, 09:37 AM
Replies: 38
Views: 13,902
Posted By Jeff in TO
Thanks to all who read and responded. My...

Thanks to all who read and responded.

My shopping list will be:

- cap + rotor
- moyer coil
- wire set

Hope everyone has a great summer season!
Forum: Troubleshooting 07-21-2014, 11:30 PM
Replies: 38
Views: 13,902
Posted By Jeff in TO
thx, RC, I have spent some time Sunday eve and...

thx, RC, I have spent some time Sunday eve and today searching through and I have read quite a few of those coil posts. I think I have also proven from the test above there's some kind of output...
Forum: Troubleshooting 07-21-2014, 11:01 PM
Replies: 38
Views: 13,902
Posted By Jeff in TO
Question Ignition shutdown problem

Hey everyone,

My buddy's engine will run about 1.5 hours, starts and runs perfectly.. gets 'hot' and then shuts down on him. Won't restart until it's had a rest. Then starts and runs great all...
Forum: Ignition System 11-01-2009, 10:18 PM
Replies: 21
Views: 10,264
Posted By Jeff in TO
Interesting point on spare parts, Shawn. (pardon...

Interesting point on spare parts, Shawn. (pardon the pun :D)

....So my question is about routine, regular maintenance:

When one switches over to electronic ignition, what parts need...
Forum: Ignition System 11-01-2009, 09:58 PM
Replies: 21
Views: 10,264
Posted By Jeff in TO
Electronic Ignition Maintenance Question

OK Gents, good discussion. I have a dumb question on ignition maintenance:

I have the conventional delco distributor, so every two or three seasons, I replace cap, rotor, points, consenser, plugs...
Forum: Troubleshooting 10-13-2007, 11:05 PM
Replies: 1
Views: 4,271
Posted By Jeff in TO
Low Oil Pressure Reading

(original) Oil pressure gauge reads 80 when the key is turned, and 0 when the engine is running. Tested the blue wire connecting the sender to the gauge - ok. Disconnected it and ran a separate...
Forum: Fuel System 02-28-2007, 08:12 PM
Replies: 28
Views: 49,058
Posted By Jeff in TO
Awesome thread, Gentlemen. I will certainly take...

Awesome thread, Gentlemen. I will certainly take a look at mine!!! Thx for the shoutout, Don.

Jeff
Forum: Wanted to Buy - Engines and Engine Parts 02-25-2007, 10:44 AM
Replies: 0
Views: 6,346
Posted By Jeff in TO
Post Indigo or CDI Propeller

Wanted:

Used Indigo or CDI propeller for direct drive Atomic-4. 7/8" Shaft.


Send me a note.

Jeff
Forum: Troubleshooting 02-24-2007, 08:17 AM
Replies: 4
Views: 4,219
Posted By Jeff in TO
Is your tank ventilation OK?

HI Chas,

Could the problem be a clogged fuel tank vent?


Diagnostic:

-Run the thing up again until she starts to exhibit the problem.
-Remove the fuel filler cap.
Forum: Drive Train / Propellers 02-12-2007, 10:06 PM
Replies: 25
Views: 12,248
Posted By Jeff in TO
Good info, Jesse. Any idea what size/pitch...

Good info, Jesse. Any idea what size/pitch propeller was on there previously?
Forum: Drive Train / Propellers 02-11-2007, 09:39 AM
Replies: 25
Views: 12,248
Posted By Jeff in TO
Hi there, I'm also interested in hearing...

Hi there,

I'm also interested in hearing back from anyone who's tried both the CDI and Indigo props. I'm looking to upgrade this spring.

My boat came with a twin blade 11x7 installed.. No...
Showing results 1 to 16 of 16

 
Forum Jump

All times are GMT -4. The time now is 09:45 AM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.


Universal® is a registered trademark of Westerbeke Corporation

Copyright © 2004-2024 Moyer Marine Inc.

All Rights Reserved