Return to the home page...
Moyer Marine Atomic 4 Community - Home of the Afourians
>
Search Forums
Search Results
User Name
Remember Me?
Password
Register
FAQ
Members List
Search
Today's Posts
Mark Forums Read
Showing results 1 to 22 of 22
Search took
0.01
seconds.
Search:
Posts Made By:
svsonora
Forum:
Fuel System
10-21-2021, 03:26 AM
Replies:
2
Help me dial in my tuning (carbs/timing)
Views:
1,582
Posted By
svsonora
I took the plate off when I moved the dizzy a...
I took the plate off when I moved the dizzy a tooth or two CCW. I also lubed up the mechanism underneath. The timing was set again after that, dynamically.
Forum:
Fuel System
10-18-2021, 08:59 PM
Replies:
2
Help me dial in my tuning (carbs/timing)
Views:
1,582
Posted By
svsonora
Help me dial in my tuning (carbs/timing)
Current engine has:
Ignitor ignition kit
adjustable main and idle jet
aftermarket 55amp alternator
All else is stock.
Last friday my engine was running badly. I only managed 1400rpms, and...
Forum:
Fuel System
06-09-2021, 11:27 PM
Replies:
5
Engine only running on choke - Kinking fuel line from fuel pump to carb
Views:
1,654
Posted By
svsonora
Thanks guys. I fixed the kink -- went to a...
Thanks guys. I fixed the kink -- went to a longer line as I had plenty of room. I saw the old line, and while there was a mild kink, there definitely was still enough space for fuel to pass...
Forum:
Fuel System
06-08-2021, 01:24 AM
Replies:
5
Engine only running on choke - Kinking fuel line from fuel pump to carb
Views:
1,654
Posted By
svsonora
Engine only running on choke - Kinking fuel line from fuel pump to carb
My boat developed this problem where the engine would only run with the choke open. The carb had been cleaned recently, fuel in the engine looks good, and my fuel pump is pumping fine. I think I...
Forum:
Troubleshooting
06-08-2021, 01:16 AM
Replies:
8
Shaft Vibration saga.
Views:
2,099
Posted By
svsonora
This sounds silly but did you use the same length...
This sounds silly but did you use the same length of bolt as the ones that came out of the coupling? My bolts were touching the rear of the transmission box and every time i tightened it up, my...
Forum:
Reversing Gear
05-23-2021, 08:55 PM
Replies:
8
Reverse keeps going out of adjustment
Views:
2,074
Posted By
svsonora
As usual thanks for the help. I had reverse...
As usual thanks for the help. I had reverse throughout my entire trip today - finally got to dock under power in my really tight sip (I usually walk the boat in)
Forum:
Reversing Gear
05-19-2021, 09:41 PM
Replies:
8
Reverse keeps going out of adjustment
Views:
2,074
Posted By
svsonora
I took the clip retaining bolt out today, and...
I took the clip retaining bolt out today, and sure enough, the bottom arm was gone. I did a safety wire looped CCW around the adjustment bolt that ran to the retention bolt. Hopefully this does the...
Forum:
Reversing Gear
05-17-2021, 09:31 PM
Replies:
8
Reverse keeps going out of adjustment
Views:
2,074
Posted By
svsonora
same thing happens if I move the lever from hte...
same thing happens if I move the lever from hte engine side.
Al, i never thought to look under the bolt. I did have, at some point, that bolt wired up with safety wire and I still lost reverse....
Forum:
Reversing Gear
05-16-2021, 11:38 PM
Replies:
8
Reverse keeps going out of adjustment
Views:
2,074
Posted By
svsonora
I'm sitting at home thinking about this problem,...
I'm sitting at home thinking about this problem, and I just think it *has* to be the adjustment nut backing out, despite my clip being intact. I can't think of any other reason why I would not have...
Forum:
Reversing Gear
05-16-2021, 09:42 PM
Replies:
8
Reverse keeps going out of adjustment
Views:
2,074
Posted By
svsonora
Reverse keeps going out of adjustment
I bought the excellent service manual from moyer marine, and followed the adjustment procedures do the dot. I adjusted forward, then reverse. I had a good 2 inches left on the rear movement of the...
Forum:
Troubleshooting
05-08-2021, 09:55 PM
Replies:
9
Engine won't run in gear with alternator
Views:
1,231
Posted By
svsonora
Cleaning the points did it. Everything...
Cleaning the points did it. Everything downstream of it has been replaced, in terms of ignition. I'd replace the points and condenser too (have the parts) but I'm just gonna go with the MMI...
Forum:
Troubleshooting
05-04-2021, 11:39 PM
Replies:
9
Engine won't run in gear with alternator
Views:
1,231
Posted By
svsonora
Battery is dying for sure. Tested the battery a...
Battery is dying for sure. Tested the battery a while back. (and if I had this knowledge you gave me on this thread before, I prob wouldn't be asking this question! ) So the only thing left to do...
Forum:
Troubleshooting
05-04-2021, 10:27 PM
Replies:
9
Engine won't run in gear with alternator
Views:
1,231
Posted By
svsonora
Thanks. I think I'm figuring this out. I will...
Thanks. I think I'm figuring this out. I will have to test my alternator tomorrow to make sure, but I think what is going on is the alternator is trying to charge the dead battery (several years...
Forum:
Troubleshooting
05-04-2021, 08:38 PM
Replies:
9
Engine won't run in gear with alternator
Views:
1,231
Posted By
svsonora
Sorry, I think what I'm not understanding is --...
Sorry, I think what I'm not understanding is -- is it normal for engine to run that roughly (e.g. die in gear + idle throttle) if the alternator is under load to try to charge up a dead battery?
Forum:
Troubleshooting
05-04-2021, 08:06 PM
Replies:
9
Engine won't run in gear with alternator
Views:
1,231
Posted By
svsonora
Thanks. I am a bit confused. What would I...
Thanks. I am a bit confused. What would I obtain from this test? Aside from checking if the alternator charges or not? (I believe it does, because it does charge up batteries faster than my solar...
Forum:
Troubleshooting
05-04-2021, 07:04 PM
Replies:
9
Engine won't run in gear with alternator
Views:
1,231
Posted By
svsonora
Engine won't run in gear with alternator
My starting bank is on its way out, and while it somewhat holds a charge, its not holding 100% charge. (75ah battery) House bank is primarily used (150AH) until I get a new starting bank.
I...
Forum:
Troubleshooting
05-04-2021, 12:02 AM
Replies:
3
Valve adjustment symptoms
Views:
1,172
Posted By
svsonora
Valve adjustment symptoms
Quick question: what happens if you never adjust your valve clearance on an A4? What would be the symptoms? Hard start? Engine stopping after running a while?
Forum:
General Interest
09-17-2020, 07:21 PM
Replies:
10
Propshaft alignment with split hub - visible movement
Views:
1,949
Posted By
svsonora
Thanks. I've been wanting to join much sooner,...
Thanks. I've been wanting to join much sooner, but I think my application for membership got overlooked. I used a different email or something. But I did read through a lot of the posts here.
...
Forum:
General Interest
09-16-2020, 06:07 PM
Replies:
10
Propshaft alignment with split hub - visible movement
Views:
1,949
Posted By
svsonora
Okay. so big DUH moment. After 5 days of...
Okay. so big DUH moment. After 5 days of wrestling with this...
I went in with feeler gauges, working my way down from 0.003" to 0.0015" Slowly tightened the sections where there was a gap...
Forum:
General Interest
09-16-2020, 03:32 AM
Replies:
10
Propshaft alignment with split hub - visible movement
Views:
1,949
Posted By
svsonora
No. I'm going to try it next time I'm at the...
No. I'm going to try it next time I'm at the boat.
I wonder if I ruined the output coupling when I was trying to pop off the old shaft from the old coupler. I'd give the bolts about a turn,...
Forum:
General Interest
09-16-2020, 12:15 AM
Replies:
10
Propshaft alignment with split hub - visible movement
Views:
1,949
Posted By
svsonora
Thanks. Any chance that my coupler was...
Thanks. Any chance that my coupler was misaligned to the shaft when I tapped it in?
Forum:
General Interest
09-15-2020, 07:43 PM
Replies:
10
Propshaft alignment with split hub - visible movement
Views:
1,949
Posted By
svsonora
Propshaft alignment with split hub - visible movement
I'm using a
1. new shaft
2. new split coupler
3. new shaft bearing
The shaft is 20 inches long, going into a direct drive transmission. Vessel is a Bristol 30 with a hard-mount (e.g. shim...
Showing results 1 to 22 of 22
Forum Jump
User Control Panel
Private Messages
Subscriptions
Who's Online
Search Forums
Forums Home
Announcements
Introductions
Drawings and Schematics
Testing Protocols
Discussion Topics
General Interest
Polls
Helpful Videos
ABYC and USCG Standards
Troubleshooting
General Maintenance
Ignition System
Electrical
Fuel System
Cooling System
Reversing Gear
Exhaust System
Drive Train / Propellers
Overhaul
Safety
Aftermarket Kits and Accessories
Specialty Tools
Moyer Marine Pin-Up's
Good Guys
Links of Particular Interest
The Wish List
Owner Discussion Groups
Discussion Groups
Alberg
Bristol
C&C
Cal
Catalina
Columbia
Dyer Glamour Girl
Ericson
Grampian
Herreshoff
Irwin
Islander
Morgan
Newport
O'Day
Pearson
Ranger
Sabre
Tartan
Classified Ads
For Sale - Engines and Engine Parts
For Sale - Other Items
Wanted to Buy - Engines and Engine Parts
Wanted to Buy - Other items
Tools wanted or offered to rent
All times are GMT -4. The time now is
02:50 PM
.
Moyer Marine Inc.
-
Archive
-
Top
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Universal® is a registered trademark of Westerbeke Corporation
Copyright © 2004-2024 Moyer Marine Inc.
All Rights Reserved