Forum: Electrical
04-22-2014, 08:19 PM
|
Replies: 22
Views: 7,581
Perception is an issue ;-)
For those who remember last falls infamous p-trap wet section, you have seen the area I'm thinking of dropping the start battery, in the lazarette about a foot and a half from the alternator so...
|
Forum: Electrical
04-21-2014, 10:47 PM
|
Replies: 22
Views: 7,581
What discouraged you from this re-location?
What discouraged you from this re-location?
C&C's had batteries located both in the 34' (hundreds built) style under the quarter berth and in the engine compartment ala 27's (near a thousand...
|
Forum: Exhaust System
10-27-2013, 09:20 PM
|
Replies: 35
Views: 10,512
Standpipe vs. Waterlift
What would the noise implications be if the water lift were phased out of the system?
The current setup after the water lift rises a good 2 feet above the waterline then exits (still above the...
|
Forum: Exhaust System
10-21-2013, 08:53 PM
|
Replies: 24
Views: 28,732
From Canada Eh!
When I rebuilt my hot section this week I used MASTERS® METALLIC COMPOUND by G. F. Thompson Co. Ltd., Newmarket, Ontario, Canada...
|
Forum: Exhaust System
10-21-2013, 07:54 PM
|
Replies: 35
Views: 10,512
And now for the rest of the Story
It's taken a bit to get it all done but here's what I came up with.
http://www3.sympatico.ca/b.johnston/images/ExhHot.jpg
Now a further question is it normal for the pre through hull tube to...
|
Forum: Exhaust System
09-27-2013, 12:32 AM
|
Replies: 35
Views: 10,512
Idling while the sails pull
Shawn,
Thank you, I was following you on the idling out of gear to keep the water out.
(edit if the wind dies I did see 6.5 on the knot meter at what didn't sound like anywhere near 3000...
|
Forum: Exhaust System
09-26-2013, 10:54 PM
|
Replies: 35
Views: 10,512
Dividing 1 90 in half
Thats really out of the box thinking!
I hope I have enough space (flange to muffler) to try this.
I'll mull it over as we idle back home (plenty of fuel @ 1 gph)
Bruce
|
Forum: Exhaust System
09-26-2013, 10:10 PM
|
Replies: 35
Views: 10,512
A lot to catch up on.
Thank you all there are a couple things I didn't think of here.
Jeff I think it could be turned end for end but I'm not sure the height of the vacuum break would be high enough.
Just to clarify...
|
Forum: Exhaust System
09-26-2013, 08:06 PM
|
Replies: 35
Views: 10,512
Will tread lightly
Mo & SAStanley,
Thank you I'll be sure to start with raw water off then open when running.
Unfortunately I can't put off the transit.
I hope to have a broad reach on the way home as...
|
Forum: Exhaust System
09-26-2013, 05:08 PM
|
Replies: 35
Views: 10,512
email not visible to me
Sorry Al your email is not visible to me (either in this thread or the member profile)
I have generated a new link. Is the post photo visible now?
|
Forum: Exhaust System
09-26-2013, 09:51 AM
|
Replies: 35
Views: 10,512
Is my hot section really built upside down here?
A few questions so I don't make a costly mistake.
I've just purchased my first boat C&C34 which luckily has a Moyer rebuilt A4 in it. (SN 201171)
I'm taking her to my home port of Hamilton from...
|