Return to the home page...
Moyer Marine Atomic 4 Community - Home of the Afourians
>
Search Forums
Search Results
User Name
Remember Me?
Password
Register
FAQ
Members List
Search
Today's Posts
Mark Forums Read
Showing results 1 to 18 of 18
Search took
0.02
seconds.
Search:
Posts Made By:
guylogan
Forum:
Specialty Tools
08-03-2019, 04:47 PM
Replies:
2
replacing/checking impellers
Views:
4,646
Posted By
guylogan
replacing/checking impellers
New engine & FWC (mm) 04/2014. replaced raw water impeller in 2016, looking back at it, it most likely didn't need it. so now I'm going to replace both since its been 3-5 years. My question is should...
Forum:
Cooling System
08-03-2019, 04:47 PM
Replies:
2
replacing/checking impellers
Views:
2,589
Posted By
guylogan
replacing/checking impellers
New engine & FWC (mm) 04/2014. replaced raw water impeller in 2016, looking back at it, it most likely didn't need it. so now I'm going to replace both since its been 3-5 years. My question is should...
Forum:
Cooling System
09-02-2016, 02:27 PM
Replies:
2
Replacing zincs in HX
Views:
2,240
Posted By
guylogan
Thanks just what I needed to know, I'll now order...
Thanks just what I needed to know, I'll now order the parts from MMI
Forum:
Cooling System
08-31-2016, 03:03 PM
Replies:
2
Replacing zincs in HX
Views:
2,240
Posted By
guylogan
Replacing zincs in HX
Just read that this is a annual job.. been two years since install of new MMI engine with new block and have enjoyed the pleasure of instant start and smooth running. So I think I should also remove...
Forum:
General Interest
06-01-2014, 05:46 PM
Replies:
16
Practical Salior article
Views:
4,675
Posted By
guylogan
Practical Sailor article
The current issue has a review of an Alberg 35, in it they slam the "ubiquitous Atomic Four" and advocate its replacement with a diesel.
I responded to them..
"I think the "Afourians" would...
Forum:
General Interest
04-23-2014, 01:57 AM
Replies:
12
Need solution for Ethanol problem
Views:
3,654
Posted By
guylogan
Of course we are..This is California were the...
Of course we are..This is California were the ya-hoos that run this state never pass up the chance to tax us. Of course the gas tax use to pay for roads and freeways but now they use it for anything...
Forum:
General Interest
04-22-2014, 04:12 PM
Replies:
12
Need solution for Ethanol problem
Views:
3,654
Posted By
guylogan
If you notice I live in California, the land of...
If you notice I live in California, the land of fruits and nuts and all fuel is E10.
I do have a source for 0 ethanol here, they call it racing fuel and charge about twice the price for it.
Forum:
General Interest
04-22-2014, 02:44 PM
Replies:
12
Need solution for Ethanol problem
Views:
3,654
Posted By
guylogan
Need solution for Ethanol problem
I'd like to start a thread to find out what are the best practices for dealing with the problem we all face, that most of the gasoline has ethanol in it and the recomendation from some that we...
Forum:
Good Guys
02-24-2014, 03:48 AM
Replies:
20
Good Guy in San Diego to install rebuilt engine.
Views:
18,876
Posted By
guylogan
Jim where is your boat on Harbor Island. I have a...
Jim where is your boat on Harbor Island. I have a Coronado 25 at Harbor Island West #333. mabey we can get to gether some time.
Russ I have the diagram where the engine compartment was cut, I'm...
Forum:
Good Guys
02-20-2014, 03:58 PM
Replies:
20
Good Guy in San Diego to install rebuilt engine.
Views:
18,876
Posted By
guylogan
still making a plan
Thanks for the comments, I went down to Shelter Island Boat yard yesterday and talked to Steve Hoffman of Hoffman Marine. I didn’t think he would do it but I thought he would give me a decent...
Forum:
Good Guys
02-18-2014, 02:21 PM
Replies:
20
Good Guy in San Diego to install rebuilt engine.
Views:
18,876
Posted By
guylogan
Good Guy in San Diego to install rebuilt engine.
I'm giving up and plan on buying a exchange engine from MMI, will need to find a yard or shop to do the swap. I have worked with both Shelter Island Boat yard and with Driscol and found both great...
Forum:
Troubleshooting
11-15-2013, 05:59 PM
Replies:
21
No start and no vacuum on start
Views:
5,240
Posted By
guylogan
Thanks dave, I most likley won't get around to...
Thanks dave, I most likley won't get around to any more checking till after Thanksgiving. Travling to Kentucky and Florida for the holiday. So thanks for the input and I'll get back online when I get...
Forum:
Troubleshooting
11-15-2013, 05:31 PM
Replies:
21
No start and no vacuum on start
Views:
5,240
Posted By
guylogan
The last time it ran everything was normal, that...
The last time it ran everything was normal, that was about a month ago now.
I diden't know that the position of the throttle could effect a compression test. I'm sure it was closed when I did that...
Forum:
Troubleshooting
11-15-2013, 02:05 PM
Replies:
21
No start and no vacuum on start
Views:
5,240
Posted By
guylogan
Quality of the spark wow, I tested with a inline...
Quality of the spark wow, I tested with a inline plug tester and the spark was defintely yellow but seemed robust. I'm more concerned with the decreasing compression readings, a coulple of months ago...
Forum:
Troubleshooting
11-15-2013, 03:46 AM
Replies:
21
No start and no vacuum on start
Views:
5,240
Posted By
guylogan
Today I double checked the choke closing by...
Today I double checked the choke closing by pulling the flame arrester off and checking that it was closed. I also put my hand over the carb throat and cranked it and got 10 inches of vacuum. I'm...
Forum:
Troubleshooting
11-13-2013, 09:25 PM
Replies:
21
No start and no vacuum on start
Views:
5,240
Posted By
guylogan
There is one thing I thought about and that is a...
There is one thing I thought about and that is a plugged exhaust, I din't know how to test for it other that pulling the exhaust from the back of the manifold. Or I could open the cap on the front of...
Forum:
Troubleshooting
11-13-2013, 12:56 PM
Replies:
21
No start and no vacuum on start
Views:
5,240
Posted By
guylogan
Thanks guys for the help. What does clean up the...
Thanks guys for the help. What does clean up the valves mean? The choke was closed when I was cranking and there was fuel in te bottom of the bowl.
I had tried ether but it dident help. Thanks...
Forum:
Troubleshooting
11-13-2013, 04:58 AM
Replies:
21
No start and no vacuum on start
Views:
5,240
Posted By
guylogan
No start and no vacuum on start
Need advise on getting her started. I'v done all the troubleshooting outlined in the manuals, got spark at the plugs and coil, compression not great (50's dry 85 wet). no fuel in cylinders. So I...
Showing results 1 to 18 of 18
Forum Jump
User Control Panel
Private Messages
Subscriptions
Who's Online
Search Forums
Forums Home
Announcements
Introductions
Drawings and Schematics
Testing Protocols
Discussion Topics
General Interest
Polls
Helpful Videos
ABYC and USCG Standards
Troubleshooting
General Maintenance
Ignition System
Electrical
Fuel System
Cooling System
Reversing Gear
Exhaust System
Drive Train / Propellers
Overhaul
Safety
Aftermarket Kits and Accessories
Specialty Tools
Moyer Marine Pin-Up's
Good Guys
Links of Particular Interest
The Wish List
Owner Discussion Groups
Discussion Groups
Alberg
Bristol
C&C
Cal
Catalina
Columbia
Dyer Glamour Girl
Ericson
Grampian
Herreshoff
Irwin
Islander
Morgan
Newport
O'Day
Pearson
Ranger
Sabre
Tartan
Off-Topic
General Discussion (Off-Topic)
Boat Construction/Repair
Captain's Confession
Weather
Marine Electronics / Interfacing and Integration
iPad/Tablet/Laptop Applications on the Water
Classified Ads
For Sale - Engines and Engine Parts
For Sale - Other Items
Wanted to Buy - Engines and Engine Parts
Wanted to Buy - Other items
Tools wanted or offered to rent
All times are GMT -4. The time now is
09:41 PM
.
Moyer Marine Inc.
-
Archive
-
Top
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Universal® is a registered trademark of Westerbeke Corporation
Copyright © 2004-2024 Moyer Marine Inc.
All Rights Reserved