Forum: General Maintenance
02-18-2009, 06:27 PM
|
Replies: 112
Views: 168,983
Mr. Close Reach
Well I'm no expert, but seeing anti freeze around the spark plug isn't a good sign. If it wasn't there before the temperature drop and it is now,,, same with the finding anti freeze in the bilge.
...
|
Forum: Reversing Gear
02-18-2009, 04:41 AM
|
Replies: 3
Views: 3,502
If you have adjusted everything and still don't...
If you have adjusted everything and still don't have any thrust I have to wonder about your prop. How fouled is it? I ran into that just a few months ago, great running A4 but instead of 6 knots I...
|
Forum: Cooling System
02-15-2009, 06:52 AM
|
Replies: 1
Views: 4,430
Raw water strainer
We are planning a trip from Norfolk to Elizabeth City by way of the Great Dismal Swamp in a few months. We'll be running the A4 for almost all of the trip, about 60 miles each way. Our boat does...
|
Forum: General Interest
02-09-2009, 04:55 AM
|
Replies: 19
Views: 8,319
|
Forum: General Interest
02-03-2009, 10:16 PM
|
Replies: 7
Views: 5,756
|
Forum: Cooling System
02-03-2009, 10:08 PM
|
Replies: 7
Views: 3,231
|
Forum: Troubleshooting
02-02-2009, 08:57 PM
|
Replies: 19
Views: 15,744
|
Forum: General Maintenance
01-24-2009, 09:56 PM
|
Replies: 2
Views: 5,699
Rick the engine doesn't really get hot so you...
Rick the engine doesn't really get hot so you don't really need the high temp stuff. I have been using a can of rustoleum for years. I can hit the rust sots with a wire brush and touch it up...
|
Forum: Cooling System
01-23-2009, 05:12 AM
|
Replies: 7
Views: 5,633
I would just go with the bolt hole stud kit. ...
I would just go with the bolt hole stud kit. It's easier and a lot faster.
We sheared one of the bolts off in my side plate repair back in May, then broke the drill bit trying to drill out the...
|
Forum: Cooling System
01-21-2009, 03:47 PM
|
Replies: 7
Views: 5,633
|
Forum: Cooling System
01-19-2009, 08:31 PM
|
Replies: 20
Views: 9,781
If it is not the bolt holes, if it's not the...
If it is not the bolt holes, if it's not the gasket to engine joint, if it's not the back plate and it's not the T-fitting or side plate,,, the weep hole is certainly suspect.
I thought it was a...
|
Forum: Overhaul
01-16-2009, 07:51 PM
|
Replies: 36
Views: 10,885
|
Forum: Introductions
01-15-2009, 05:19 AM
|
Replies: 4
Views: 6,376
gfatula makes a good point about the sea water...
gfatula makes a good point about the sea water inlet. Keep it shut until the engine starts. Also, make sure you check the oil level. Once she is up and running you don't need a new problem. If...
|
Forum: Reversing Gear
01-14-2009, 04:56 AM
|
Replies: 16
Views: 10,234
|
Forum: Cooling System
01-14-2009, 04:35 AM
|
Replies: 20
Views: 9,781
|
Forum: Cooling System
01-13-2009, 07:28 PM
|
Replies: 20
Views: 9,781
|
Forum: Reversing Gear
01-13-2009, 07:21 PM
|
Replies: 3
Views: 3,143
|
Forum: Reversing Gear
01-13-2009, 02:30 PM
|
Replies: 3
Views: 3,143
mauijim,
The engine with the two rounded...
mauijim,
The engine with the two rounded corners is an early model A4 made up to 1967. The other one was built after 1968. Looking in the parts manual I do not see a different arrangement unless...
|
Forum: Cooling System
01-11-2009, 11:25 AM
|
Replies: 2
Views: 5,521
|
Forum: Reversing Gear
01-08-2009, 04:28 PM
|
Replies: 16
Views: 10,234
|
Forum: Introductions
01-07-2009, 09:19 PM
|
Replies: 11
Views: 8,353
Welcome to the group. We all started out not...
Welcome to the group. We all started out not knowing a lot about the A4 but this group will certainly help you out and Don always offers his guidance when needed. Your A4 can take a lot of abuse...
|
Forum: Exhaust System
01-06-2009, 06:58 AM
|
Replies: 23
Views: 12,087
Your exhaust
Shawn,
I have been following this thread a while now and chimed in on a couple others about exhaust systems. I don't have any pictures of mine, but I do have a system drawing and I have to say,...
|
Forum: Reversing Gear
01-05-2009, 08:34 PM
|
Replies: 3
Views: 4,654
Check out these faqs from Don- ...
Check out these faqs from Don-
http://www.moyermarine.com/faq/2.7.html
http://www.moyermarine.com/faq/2.6.html
That should take care of your problem.
|
Forum: Overhaul
01-05-2009, 04:14 PM
|
Replies: 36
Views: 10,885
|
Forum: Drive Train / Propellers
01-05-2009, 02:44 PM
|
Replies: 21
Views: 9,978
|