Forum: Electrical
02-20-2021, 08:21 PM
|
|
Replies: 3
Views: 106
|
|
Forum: Polls
02-19-2021, 01:35 PM
|
|
Replies: 6
Views: 178
|
|
Forum: Electrical
02-16-2021, 10:49 AM
|
|
Replies: 19
Views: 442
One more thing to consider in choosing the...
One more thing to consider in choosing the location...
Remember that eventually your needs (or the needs of another skipper) will change.
ie. You'll decide to add another battery to the house...
|
|
Forum: General Interest
01-23-2021, 11:17 AM
|
|
Replies: 9
Views: 385
From Don in the FAQ section:
Two years is...
From Don in the FAQ section:
Two years is not all that long for an Atomic 4 to be idle. Nonetheless, here are a few steps to help get it off to a good start:
1) Check for good quality oil (30...
|
|
Forum: Fuel System
01-19-2021, 12:41 PM
|
|
Replies: 7
Views: 427
|
|
Forum: Troubleshooting
01-18-2021, 08:43 PM
|
|
Replies: 70
Views: 2,421
|
|
Forum: Troubleshooting
01-18-2021, 06:28 PM
|
|
Replies: 70
Views: 2,421
|
|
Forum: Troubleshooting
01-15-2021, 01:00 PM
|
|
Replies: 70
Views: 2,421
|
|
Forum: General Interest
01-09-2021, 01:29 PM
|
|
Replies: 20
Views: 1,216
One piece of valuable gear we neglected to...
One piece of valuable gear we neglected to mention is an AUTO HELM or autopilot...
I made one long journey and crossing on a vessel without one and would never want to do it again.
A reliable...
|
|
Forum: General Interest
01-03-2021, 12:48 PM
|
|
Replies: 20
Views: 1,216
|
|
Forum: General Interest
01-03-2021, 12:45 PM
|
|
Replies: 20
Views: 1,216
|
|
Forum: General Interest
12-31-2020, 12:21 PM
|
|
Replies: 39
Views: 1,305
|
|
Forum: General Interest
12-30-2020, 01:21 PM
|
|
Replies: 39
Views: 1,305
|
|
Forum: Fuel System
12-23-2020, 11:48 AM
|
|
Replies: 10
Views: 459
As Tom says, a GOOD FITTING slash tube goes a...
As Tom says, a GOOD FITTING slash tube goes a long way.
To that point, Tom made one of his special "Thatch Mod" slash tubes for me a few years ago.
Since then, my older engine runs much better and...
|
|
Forum: Troubleshooting
12-08-2020, 11:31 AM
|
|
Replies: 17
Views: 620
COMPRESSION TEST PROCEDURE
Test the engine...
COMPRESSION TEST PROCEDURE
Test the engine while its warm, as you'll get different readings hot and cold.
Your readings will be higher on a hot engine, but if it passes cold it will pass hot.
...
|
|
Forum: Introductions
11-27-2020, 12:21 PM
|
|
Replies: 11
Views: 9,785
|
|
Forum: Troubleshooting
11-14-2020, 01:30 PM
|
|
Replies: 10
Views: 599
|
|
Forum: Fuel System
11-10-2020, 07:41 PM
|
|
Replies: 9
Views: 673
|
|
Forum: Exhaust System
10-25-2020, 07:23 PM
|
|
Replies: 13
Views: 1,273
|
|
Forum: Cooling System
10-07-2020, 01:47 PM
|
|
Replies: 17
Views: 952
Barbara-
Doing all of the bolts with the...
Barbara-
Doing all of the bolts with the backing plate kits is a good way to go.
(I wish I'd done mine at the time of my repair)
As Neal says, "Do it right... only cry once"
As far as Permatex...
|
|
Forum: Cooling System
10-06-2020, 11:32 AM
|
|
Replies: 17
Views: 952
Barbara-
Note that you can easily cut the...
Barbara-
Note that you can easily cut the backing plate of the repair kit in half if you just want to do only one bolt hole.
The JB Weld will hold it in place. (See pics)
Of course, there is...
|
|
Forum: Introductions
09-26-2020, 07:35 PM
|
|
Replies: 7
Views: 669
Another welcome to the crew!
You would also...
Another welcome to the crew!
You would also be well served investing in the MMI Bible (https://moyermarine.com/product/service-and-overhaul-manual/) as well as viewing some of Don's VIDEOS...
|
|
Forum: Introductions
09-22-2020, 09:00 PM
|
|
Replies: 3
Views: 605
|
|
Forum: Troubleshooting
09-15-2020, 11:49 AM
|
|
Replies: 51
Views: 3,379
|
|
Forum: Polls
09-06-2020, 02:14 PM
|
|
Replies: 10
Views: 1,127
Not sure why you would close the engine intake...
Not sure why you would close the engine intake thru hull while underway?
There is a very high probability of needing to start your engine.
I can think of other reasons for closing it... but not...
|
