Return to the home page...

Go Back   Moyer Marine Atomic 4 Community - Home of the Afourians > Search Forums

Showing results 1 to 8 of 8
Search took 0.01 seconds.
Search: Posts Made By: sandspur
Forum: Troubleshooting 02-15-2010, 12:37 PM
Replies: 25
Views: 9,086
Posted By sandspur
If you are very careful you may be able to reuse...

If you are very careful you may be able to reuse the head gaskets. I would spay them down go with Hi Tac . bar your engine over till valves close just as you would to set them, & put some PB blaster...
Forum: Troubleshooting 02-14-2010, 08:10 PM
Replies: 25
Views: 9,086
Posted By sandspur
Valves not seating, Or stuck rings, must likely...

Valves not seating, Or stuck rings, must likely the valves ,
Forum: Ignition System 09-16-2009, 02:03 AM
Replies: 44
Views: 184,778
Posted By sandspur
Check & clean ground to block, Check voltage draw...

Check & clean ground to block, Check voltage draw at starter when trying to crank, cables may have corrosion in cables or in lugs if crimped that will cause low voltage when cranking, A bad ground...
Forum: Overhaul 09-13-2009, 11:54 PM
Replies: 23
Views: 9,015
Posted By sandspur
If you have the room above the block for the...

If you have the room above the block for the machine it can be done, Just got done doing mine, Finding some one with the machine might be the hard part If your in N. E Fla I could help
Forum: Overhaul 07-11-2009, 11:18 AM
Replies: 9
Views: 4,098
Posted By sandspur
Thank you for the info. I found 2...

Thank you for the info.
I found 2 atomic 4 manuals on the boat but they are water logged & stuck together with a lot of other books, It doesn't look like any water was in the cyl or the...
Forum: Introductions 07-11-2009, 10:39 AM
Replies: 4
Views: 5,620
Posted By sandspur
lat 64 not a problem, I...

lat 64 not a problem,
I appreciate any & all input, :D
Forum: Overhaul 07-10-2009, 11:17 AM
Replies: 9
Views: 4,098
Posted By sandspur
Valve angle

After running a compression check I found no compression on 3 of the 4 cyl so I pulled the head & found 2 intake valves stuck open & the others not seating, Are the valve angles 45/45 or 45/30 ?
Forum: Introductions 07-10-2009, 11:07 AM
Replies: 4
Views: 5,620
Posted By sandspur
New to sailing & the atomic 4

I have been looking at sailboats for about 5yrs, Have never been on one but have had power boats, after Dreaming about sailboats I found one that I fell in love with & got it, Its going to take...
Showing results 1 to 8 of 8

 
Forum Jump

All times are GMT -4. The time now is 04:24 PM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.


Universal® is a registered trademark of Westerbeke Corporation

Copyright © 2004-2024 Moyer Marine Inc.

All Rights Reserved