Return to the home page...

Go Back   Moyer Marine Atomic 4 Community - Home of the Afourians > Search Forums

Showing results 1 to 9 of 9
Search took 0.01 seconds.
Search: Posts Made By: Michael L
Forum: Troubleshooting 07-28-2007, 02:11 PM
Replies: 5
Views: 6,741
Posted By Michael L
If the fuel tank is original or metal - change...

If the fuel tank is original or metal - change it. An old tank will keep giving crud to your 'new' motor. They are not expensive when you consider the alternatives. Check your filter again....
Forum: Troubleshooting 07-28-2007, 01:59 PM
Replies: 4
Views: 4,599
Posted By Michael L
A few questions.. Are you still getting good...

A few questions.. Are you still getting good water flow through your exhaust? Does the steam have a slightly sweet smell to it? Is your coolant level unchanged? Has the engine oil emulsified...
Forum: Troubleshooting 02-28-2007, 02:34 PM
Replies: 2
Views: 4,783
Posted By Michael L
Good time to get to know your motor. First clean...

Good time to get to know your motor. First clean the rust out. Use an oily rag, or penetrating spray of some sort, fine steel wool if necessary. Coat the cylinder walls and valves/exposed valve...
Forum: C&C 02-28-2007, 02:13 PM
Replies: 2
Views: 11,878
Posted By Michael L
C&C Corvette muffler?

Has anyone tried to install a water lift muffler on their Corvette- I would be interested in hearing how.
Forum: Cooling System 07-14-2005, 11:30 PM
Replies: 9
Views: 7,498
Posted By Michael L
Reading your woes sounded a little familiar. I...

Reading your woes sounded a little familiar. I found that reverse flushing the block would clean out my spontaneous blockage/ overheating problems, and its easy. Remove your thermostat, block...
Forum: Troubleshooting 06-21-2005, 01:03 PM
Replies: 2
Views: 5,743
Posted By Michael L
Last year (my first with the A4) I was having the...

Last year (my first with the A4) I was having the same problem, which in the end seemed to be caused by overfilling the crank case with oil, and only by a small amount over the "full" line on the dip...
Forum: Troubleshooting 06-06-2005, 11:46 PM
Replies: 3
Views: 7,335
Posted By Michael L
Did as you said, and detect no leak, in fact I...

Did as you said, and detect no leak, in fact I was surprised how good it looked in there. The leak sounds as if it is coming from a lower location than is visible through the valve cover, and at the...
Forum: Troubleshooting 06-04-2005, 07:01 PM
Replies: 3
Views: 7,335
Posted By Michael L
Is a cracked block reparable?

I have been getting water in the oil, and have checked waterpump, exhaust system, and behind valve cover plate and have seen nothing. Today I preasurized the block to 20psi, with air, and lost all...
Forum: Troubleshooting 05-25-2005, 11:44 PM
Replies: 74
Views: 103,007
Posted By Michael L
Water in oil

Sounds like we have the same problem. Ran motor for 45 min. when I noticed a drop in oil pressure. The oil had gone grey. Looks as though an entire quart of water was introduced to the lube system...
Showing results 1 to 9 of 9

 
Forum Jump

All times are GMT -4. The time now is 04:44 AM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.


Universal® is a registered trademark of Westerbeke Corporation

Copyright © 2004-2024 Moyer Marine Inc.

All Rights Reserved