Return to the home page...

Go Back   Moyer Marine Atomic 4 Community - Home of the Afourians > Search Forums
Register FAQ Community Today's Posts Search

Showing results 1 to 16 of 16
Search took 0.01 seconds.
Search: Posts Made By: yeahmag
Forum: Drive Train / Propellers Yesterday, 02:28 PM
Replies: 15
Views: 259
Posted By yeahmag
Thanks, everyone. I do run 87 in the motor along...

Thanks, everyone. I do run 87 in the motor along with Marine StaBil. I don't have reasonable access to non-ethanol gas here in SoCal. It did make me wonder if I should ream the main jet a tiny bit to...
Forum: Drive Train / Propellers 04-15-2024, 12:12 PM
Replies: 15
Views: 259
Posted By yeahmag
I'm using the Pertronix unit from MM. I do plan...

I'm using the Pertronix unit from MM. I do plan on checking to make sure the advance is working properly and then power timing it. I believe I set the float to the default value of 1 5/32"

I've...
Forum: Drive Train / Propellers 04-09-2024, 07:35 PM
Replies: 15
Views: 259
Posted By yeahmag
Hull speed is reportedly about 6.8Kts and I can...

Hull speed is reportedly about 6.8Kts and I can almost reach that. I think I'll make sure the distributor is advancing properly and then retime it next.

I did a head gasket on it a few years ago...
Forum: Drive Train / Propellers 04-08-2024, 03:10 PM
Replies: 15
Views: 259
Posted By yeahmag
Indigo Prop

I just installed the Indigo prop along with an all new 316SS wet exhaust and am pleased with the upgrade. I can cruise easily at 6kts now on my 1972 Ranger 33. I still really can't get above 1900...
Forum: Cooling System 03-06-2023, 05:22 PM
Replies: 3
Views: 893
Posted By yeahmag
Salt Gone Engine Flush

Has anyone tried the (heavily advertised) Salt Gone product for engine flushing instead of using muriatic acid? It says a lot of good things...

-Aaraon
Forum: Cooling System 11-08-2022, 01:51 PM
Replies: 8
Views: 1,208
Posted By yeahmag
Before my ownership it was run with (i believe) a...

Before my ownership it was run with (i believe) a non functional automotive style thermostat in the stock, late housing with no restriction on the side plate. In this mode the temp would never come...
Forum: Cooling System 11-07-2022, 02:12 PM
Replies: 8
Views: 1,208
Posted By yeahmag
Temp Gauge Fluctuates

I'm not certain this is a problem, but for the first 20-30 minutes of cruising, the temp gauge swings back and forth from 170F-200F. This is a RWC engine with a Moyer thermostat in it. After extend...
Forum: Electrical 01-12-2022, 12:24 PM
Replies: 3
Views: 1,054
Posted By yeahmag
Temp Gauge Issue

My temperature gauge is not working normally. Prior to my head gasket and thermostat replacement I never got any temp readings on the gauge. I found the previous owner had effectively no thermostat...
Forum: Electrical 01-25-2021, 12:16 PM
Replies: 6
Views: 1,407
Posted By yeahmag
I've checked on all the connections, but I'd gone...

I've checked on all the connections, but I'd gone back and forth with the pipe dope. The sender worked well last time it was out, but it tends to go from reading correct (or at least close to my IR...
Forum: Electrical 01-24-2021, 11:55 PM
Replies: 6
Views: 1,407
Posted By yeahmag
Temperature Sender

Can anyone identify the gauge or sender? I'd like to replace the sender due to erratic gauge readings.

Thanks

-Aaron
Forum: Troubleshooting 11-23-2020, 01:45 PM
Replies: 17
Views: 2,924
Posted By yeahmag
Fastest run from yesterday's race: ...

Fastest run from yesterday's race:

https://youtu.be/beDDzUPel00
Forum: Troubleshooting 11-21-2020, 03:06 PM
Replies: 17
Views: 2,924
Posted By yeahmag
Got a race tomorrow. Wish me luck! 15522

Got a race tomorrow. Wish me luck!

15522
Forum: Troubleshooting 11-19-2020, 01:25 AM
Replies: 17
Views: 2,924
Posted By yeahmag
Porsche 914 (4 cylinder air cooled)

Porsche 914 (4 cylinder air cooled)
Forum: Troubleshooting 11-16-2020, 08:41 PM
Replies: 17
Views: 2,924
Posted By yeahmag
I data log with an Innovate Motorsports LM-2 and...

I data log with an Innovate Motorsports LM-2 and use an Aircraft Spruce M1000 CHT on the 914.
Forum: Troubleshooting 11-16-2020, 12:37 PM
Replies: 17
Views: 2,924
Posted By yeahmag
Neil, Thanks for the worksheets, example,...

Neil,

Thanks for the worksheets, example, and tips. I'll try and do this next time I'm down. I've got an IR gun and lot's of experience with motors. Unfortunately, most of that experience is with...
Forum: Troubleshooting 11-15-2020, 10:51 PM
Replies: 17
Views: 2,924
Posted By yeahmag
Chaotic Engine Temps

I recently changed out a head gasket due to failure and rebuilt the carb as a result. I also did an acid flush and added the MM thermostat (late engine) and now finally have temperature showing on my...
Showing results 1 to 16 of 16

 
Forum Jump

All times are GMT -4. The time now is 10:43 PM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.


Universal® is a registered trademark of Westerbeke Corporation

Copyright © 2004-2024 Moyer Marine Inc.

All Rights Reserved