Return to the home page...

Go Back   Moyer Marine Atomic 4 Community - Home of the Afourians > Search Forums

Showing results 1 to 4 of 4
Search took 0.00 seconds.
Search: Posts Made By: Al Schober
Forum: Troubleshooting 06-24-2019, 08:05 PM
Replies: 23
Views: 9,793
Posted By Al Schober
No, that's not it. Thickness is to fit into that...

No, that's not it. Thickness is to fit into that slot. ID about 1/8 or 3/16 (to fit the pin that goes into the hole. OD about 3/4". Get a magnet on a stick and go fishing in your transmission -...
Forum: Troubleshooting 06-24-2019, 04:53 PM
Replies: 23
Views: 9,793
Posted By Al Schober
I looked at your photo, and something isn't...

I looked at your photo, and something isn't right.
I suspect the roller is missing. There is supposed to be a riveted pin holding a roller in that slot. If the pin shears, the roller ends up in...
Forum: Troubleshooting 06-23-2019, 06:31 PM
Replies: 23
Views: 9,793
Posted By Al Schober
I recommend you back off on your fwd adjustment. ...

I recommend you back off on your fwd adjustment. Sounds like the fwd adjustment is MUCH too tight, preventing the transmission linkage from going into fwd.
Similar for the reverse adjustment -...
Forum: Troubleshooting 06-22-2019, 07:13 PM
Replies: 23
Views: 9,793
Posted By Al Schober
In addition to the reverse cam being...

In addition to the reverse cam being disconnected, the fwd motion isn't going 'over the hump' and engaging the notch.
Recommend you disconnect you shift linkage from the engine, then get the...
Showing results 1 to 4 of 4

 
Forum Jump

All times are GMT -4. The time now is 02:54 AM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.


Universal® is a registered trademark of Westerbeke Corporation

Copyright © 2004-2024 Moyer Marine Inc.

All Rights Reserved