Forum: General Interest
08-04-2016, 01:47 PM
|
Replies: 2
Views: 2,560
thanks
I had taken off the manifold to install a new exhaust pipe system i made, put everything back together, noticed there wasn't a gasket there . burned away? I dunno, but it always ran fine, anyway I...
|
Forum: General Interest
08-04-2016, 01:16 PM
|
Replies: 2
Views: 2,560
|
Forum: General Maintenance
06-10-2013, 10:09 AM
|
Replies: 41
Views: 117,442
MMO /sticking valves
Thanks for the input Dave and tenders, I am using MMO to help, and yes, of course cooler is better than hotter, at least better than too hot :) I read a note from Don Moyers that if your engine isn't...
|
Forum: General Maintenance
06-09-2013, 07:33 PM
|
Replies: 41
Views: 117,442
Sticking valves and MMO
Today I tried starting my Atomic 4 and it started once but ran terribly. I had it running fine a week ago. I checked the compression with my thumb- no compression in #1 &4 cylinders, I remembered...
|
Forum: General Maintenance
03-30-2013, 01:57 PM
|
Replies: 8
Views: 6,784
|
Forum: General Maintenance
03-30-2013, 09:51 AM
|
Replies: 8
Views: 6,784
Prop Shaft forCal 2-30 Atomic 4
I want to replace my prop shaft on my Cal 2-30 /Atomic 4 I'm replacing the cutless bearing and installing a PSS shaft seal. Removing the prop shaft looks like I'll have problems with the rear...
|
Forum: Troubleshooting
07-28-2012, 11:17 AM
|
Replies: 60
Views: 18,860
Distributor wired reversed direction
Thank you all for your help. The distributor was wired for counter-clockwise rotation by the original owner, I should have looked more closely at the wiring diagrams and NOT assumed the last owner...
|
Forum: Troubleshooting
07-27-2012, 07:05 PM
|
Replies: 60
Views: 18,860
|
Forum: Troubleshooting
07-27-2012, 07:04 PM
|
Replies: 60
Views: 18,860
Thanks for all tyhe help so far...if the...
Thanks for all tyhe help so far...if the distributor rotation is Clockwise....Ive got the wires wrong... I thought the guy i got the boat from would have the wires in the right direction but we all...
|
Forum: Troubleshooting
07-27-2012, 04:01 PM
|
Replies: 60
Views: 18,860
A4 backfiring thru carb, no power
Well my A4 has a new Electronic distributor from Moyer,new plug wires, brand new carb, set the distributor up engine #1 cylinder TDC and adjusted for best idle, carb idle adjustment correct, firing...
|
Forum: Ignition System
06-14-2012, 05:02 PM
|
Replies: 55
Views: 20,971
|
Forum: Ignition System
06-14-2012, 04:59 PM
|
Replies: 55
Views: 20,971
|
Forum: Ignition System
06-13-2012, 10:52 AM
|
Replies: 55
Views: 20,971
Atomic 4 distributor
Can anyone tell me which distributor I have on my Atomic 4? I'd like to upgrade it to electronic ignition and keep spare points etc for a back up. too a couple pics...
|