NEW VIDEO - Head Removal
|
Nice video. Well done.
My only suggestion would be to loosely replace the nuts after doing the wire brushing. This will allow you to tap on the nut and not damage the threads on the top of the stud. |
I think I would have left the plugs in the holes while doing the wire brushing, to keep the debris from falling into the holes.
Bill |
All times are GMT -4. The time now is 06:50 AM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Universal® is a registered trademark of Westerbeke Corporation
Copyright © 2004-2024 Moyer Marine Inc.
All Rights Reserved