Return to the home page...

Go Back   Moyer Marine Atomic 4 Community - Home of the Afourians > Search Forums
Register FAQ Community Today's Posts Search

Showing results 1 to 20 of 20
Search took 0.01 seconds.
Search: Posts Made By: keithems
Forum: Ignition System 07-23-2022, 10:15 PM
Replies: 20
Views: 4,376
Posted By keithems
yes -- he already got back to me..sent the...

yes -- he already got back to me..sent the installation intructions, pricing for a shutter, etc., etc..

i can't tell you how gracious he has been and how much i appreciate his -- and your --...
Forum: Troubleshooting 07-10-2022, 01:02 PM
Replies: 32
Views: 3,894
Posted By keithems
about last nite

tried the new spark plugs....both non resistored--autolite 437 and the champ j 8 c.

both ran fine...so i'm happy

however, i did notice that the wires also say they are resistored..can they be...
Forum: Troubleshooting 07-10-2022, 12:52 PM
Replies: 32
Views: 3,894
Posted By keithems
more details and good news.. maybe you...

more details and good news..

maybe you bought yours new or in excellent condition? or a complete overhaul...maybe with a short block from mmi?

my a 4 was well used....more or less had to take...
Forum: Fuel System 07-10-2022, 12:02 PM
Replies: 18
Views: 2,231
Posted By keithems
FWIW... here's the url re. the post by...

FWIW...

here's the url re. the post by sastanley--dated 2010, so may or may not be helpful now:

https://www.moyermarineforum.com/forums/showthread.php?t=4547

he said he had obtained a supply...
Forum: Fuel System 07-09-2022, 02:57 PM
Replies: 18
Views: 2,231
Posted By keithems
pls look at the post i just made in reply to the...

pls look at the post i just made in reply to the post above from mr moyer [# 16]

also pls look at my join date and compare to yours, so you can see ive had a lot of eaxperience wiht the a4 and...
Forum: Fuel System 07-09-2022, 02:52 PM
Replies: 18
Views: 2,231
Posted By keithems
thank you. good to know...i'm not on here...

thank you.

good to know...i'm not on here that much -- usually only when i have a problem, which has been rare the past few years..meaning my a4 has been quite reliable....starts immediately, runs...
Forum: Fuel System 07-09-2022, 11:11 AM
Replies: 18
Views: 2,231
Posted By keithems
nor do i, thank you but really if i ahd to...

nor do i, thank you

but really if i ahd to rebuild the carb every year, i'd just spring for a diesel.

what do you do when the wind dies?

i've discussed the gasket issue with ted....i...
Forum: Troubleshooting 07-09-2022, 10:56 AM
Replies: 32
Views: 3,894
Posted By keithems
of ocurse not...but if 3 cylinders are wrunning...

of ocurse not...but if 3 cylinders are wrunning fine but one is not -- usually the #4, due to its location -- it can be ignition or a sticking or stuck valve.

a4 is notorious for sticking...
Forum: Fuel System 07-09-2022, 09:07 AM
Replies: 18
Views: 2,231
Posted By keithems
never -- got it new from MMI about 2-3 years...

never -- got it new from MMI about 2-3 years ago...

and i've rebuilt carbs enough in the past to learn to live by the letters: D F W I ;)
Forum: Fuel System 07-09-2022, 09:05 AM
Replies: 18
Views: 2,231
Posted By keithems
I DON'T HAVE A MAIN BOWL GASKET..NO DRAIN ON THE...

I DON'T HAVE A MAIN BOWL GASKET..NO DRAIN ON THE BOTTOM

only the main passage plug -- where the fixed main jet is...whcih can be used to drain the main bowl, except then that gasket has to be...
Forum: Troubleshooting 07-09-2022, 08:57 AM
Replies: 32
Views: 3,894
Posted By keithems
My friend.... There is no comparison between...

My friend....

There is no comparison between your knowledge level on these matters and mine -- yours is vastly superior.

that said..on the following page i've cited so often [above], david...
Forum: Troubleshooting 07-08-2022, 09:40 PM
Replies: 32
Views: 3,894
Posted By keithems
thank you at my boat tonite..with the new...

thank you

at my boat tonite..with the new rotor and cap, figured i'd try the rj12 again..

no good

so put the j-8 back in, and all was well

no one mentioned it but the r stands for...
Forum: Fuel System 07-08-2022, 09:28 PM
Replies: 18
Views: 2,231
Posted By keithems
RIGHT -- so mmi makes you buy the entire carb...

RIGHT -- so mmi makes you buy the entire carb rebuild kit to get the one silly little gasket...such a ripoff..i found a smiilar gasket at west marine...it's for hte mercury mercruiser....don't have...
Forum: Fuel System 07-08-2022, 01:51 PM
Replies: 18
Views: 2,231
Posted By keithems
and now i remember why i'm reluctant to remove...

and now i remember why i'm reluctant to remove it....getting a replacement gasket is very difficult....i'm on my last one now...

and my carb runs very rich as is -- maybe some air is getting...
Forum: Fuel System 07-08-2022, 01:33 PM
Replies: 18
Views: 2,231
Posted By keithems
ok -- i'm seeing the "main passage plug", which...

ok -- i'm seeing the "main passage plug", which is removable....is that what you're referring to?

the hole above it is much smaller than the drain hole is on the older carbs with the drain hole on...
Forum: Fuel System 07-08-2022, 01:05 PM
Replies: 18
Views: 2,231
Posted By keithems
i'm not seeing anything i can remove to drain the...

i'm not seeing anything i can remove to drain the bowl like on the carbs i had previously

it's one of them new models....has 5 bolts holding the upper and lower halves together..the older ones i...
Forum: Fuel System 07-08-2022, 09:23 AM
Replies: 18
Views: 2,231
Posted By keithems
how do you drain the bowl on a new carburetor?

purchased and installed a new carb from mmi a few years ago.

i note that in various places Don suggests we drain that bowl if any moisture / contamination is suspected.

i'd like to..but there...
Forum: Troubleshooting 07-08-2022, 09:12 AM
Replies: 32
Views: 3,894
Posted By keithems
i followed the url cited above....if you want to...

i followed the url cited above....if you want to know more, i suggest you click on it and read all the responses..including don's

https://www.moyermarineforum.com/forums/showthread.php?t=1241
...
Forum: Troubleshooting 07-07-2022, 03:56 PM
Replies: 32
Views: 3,894
Posted By keithems
The #4 cylinder gets the least cooling and thus...

The #4 cylinder gets the least cooling and thus more wear as well as the fuel that puddles goes "down" to that cylinder. It is kind of a weak link or the first to cause problems. Is the #4 fouled...
Forum: Ignition System 09-30-2021, 12:36 PM
Replies: 2
Views: 15,922
Posted By keithems
Question ammeter view

first let me add to the kudos you've received for your wiring diagram -- especially useful to me since it's based on a c&c27, and i sail a c&c30-mk 1

a question [pls. don't laugh too loudly at my...
Showing results 1 to 20 of 20

 
Forum Jump

All times are GMT -4. The time now is 10:46 AM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.


Universal® is a registered trademark of Westerbeke Corporation

Copyright © 2004-2024 Moyer Marine Inc.

All Rights Reserved