Forum: Troubleshooting
06-11-2018, 08:53 AM
|
Replies: 76
Views: 19,378
Yeh, TBH, I find each manual, even some of the...
Yeh, TBH, I find each manual, even some of the odd parts list, handy in their own way, which is why I keep them all available in the shop.
The Moyer Marine manual is considered "The One Book to...
|
Forum: Troubleshooting
06-08-2018, 01:35 PM
|
Replies: 4
Views: 2,176
|
Forum: Troubleshooting
06-08-2018, 01:34 PM
|
Replies: 76
Views: 19,378
|
Forum: Troubleshooting
06-05-2018, 07:56 PM
|
Replies: 128
Views: 31,617
|
Forum: Troubleshooting
05-24-2018, 01:56 PM
|
Replies: 8
Views: 3,041
|
Forum: Overhaul
04-26-2018, 08:11 PM
|
Replies: 152
Views: 58,595
Shawn, if you look at the last picture you will...
Shawn, if you look at the last picture you will see the valve's mating surface, which is the larger beveled face toward the the top of the valve facing down toward the stem. That's the main area of...
|
Forum: Exhaust System
04-19-2018, 01:42 PM
|
Replies: 54
Views: 13,863
|
Forum: Ericson
04-16-2018, 04:52 PM
|
Replies: 237
Views: 104,496
Cajun, I feel you pain. Nearly all of the wood...
Cajun, I feel you pain. Nearly all of the wood on my Newport was in some form of decay or delamination, so all of it is now off. Since I'm not one that feels the need for a lot of wood surfaces in...
|
Forum: General Interest
04-16-2018, 11:50 AM
|
Replies: 85
Views: 17,253
Update, again.
Fired up my A4 a couple of...
Update, again.
Fired up my A4 a couple of time now. First time it took off after just one stroke! Each time since then it takes it 2 or 3 stokes, but starts every time within 5 seconds of...
|
Forum: General Interest
04-11-2018, 12:35 AM
|
Replies: 85
Views: 17,253
|
Forum: Ignition System
04-06-2018, 08:47 AM
|
Replies: 1
Views: 3,384
Testing Pertronix Ignitor 1
I was having no luck with getting a spark from my ignition system.
I replaced the coil, all the wires, including the plug wires, the cap, rotor and plugs. I even wired a clean set of leads, but...
|
Forum: Troubleshooting
04-02-2018, 01:52 AM
|
Replies: 125
Views: 34,250
|
Forum: Troubleshooting
04-02-2018, 01:49 AM
|
Replies: 125
Views: 34,250
|
Forum: Ericson
04-02-2018, 01:34 AM
|
Replies: 34
Views: 19,605
|
Forum: Ericson
03-21-2018, 11:54 PM
|
Replies: 34
Views: 19,605
Alright, I can see why most coatings are shied...
Alright, I can see why most coatings are shied away from, but from that circular, it would seem phenol novolac epoxies are acceptable if you follow the manufacturer's instructions. These products are...
|
Forum: Ignition System
03-05-2018, 04:59 PM
|
Replies: 43
Views: 15,801
Okay, as many of you know, my little project, a...
Okay, as many of you know, my little project, a 1974 Newport 27, includes a complete rewiring. Some of the things I'm dealing with are the same things I've seen mentioned in this thread, such as:
...
|
Forum: Announcements
02-28-2018, 07:32 PM
|
Replies: 5
Views: 3,939
This is just an FYI for folks like me reading...
This is just an FYI for folks like me reading through old post. Since the upgrade to the forum some links were lost. This is nothing unexpected, heck, I would have been struck dumb if all the old...
|
Forum: Troubleshooting
02-14-2018, 01:28 PM
|
Replies: 125
Views: 34,250
Cajun, welcome aboard.
It sounds like you...
Cajun, welcome aboard.
It sounds like you are where I am with the compression problem. I've been trying the "pour Marvel's Mystery Oil in the block over a period of time and see what happens"...
|
Forum: General Interest
01-09-2018, 06:09 PM
|
Replies: 85
Views: 17,253
No problem. I used to play with TR4s through...
No problem. I used to play with TR4s through TR6s, but over the last 20 years I've been stuck on 1500 Spitfires. I have two 1974s (hmm, just noticed they are as old as my boat) in storage in rough...
|
Forum: General Interest
12-21-2017, 05:28 PM
|
Replies: 85
Views: 17,253
|
Forum: General Interest
12-18-2017, 10:43 PM
|
Replies: 85
Views: 17,253
|
Forum: Introductions
12-14-2017, 08:33 PM
|
Replies: 20
Views: 6,375
|