Return to the home page...

Go Back   Moyer Marine Atomic 4 Community - Home of the Afourians > Search Forums

Showing results 1 to 20 of 20
Search took 0.01 seconds.
Search: Posts Made By: Antibes
Forum: Fuel System 07-05-2023, 01:28 PM
Replies: 3
Views: 897
Posted By Antibes
Main components affected by ethanol are the...

Main components affected by ethanol are the rubber parts. Gas lines should be changed to ethanol resistant. Like Dave said sitting fuel is main problem, so don't put more in the tank than you think...
Forum: Exhaust System 06-07-2022, 12:42 PM
Replies: 7
Views: 1,697
Posted By Antibes
Skipping to your last question, no thread sealant...

Skipping to your last question, no thread sealant is needed.
Forum: Introductions 04-04-2022, 09:14 PM
Replies: 48
Views: 9,812
Posted By Antibes
There are two recommendations for oil. Rotella...

There are two recommendations for oil. Rotella Diesel 15w40 and original 30w

https://www.moyermarineforum.com/forums/showthread.php?t=6443
Forum: Introductions 03-29-2022, 12:29 PM
Replies: 48
Views: 9,812
Posted By Antibes
The anti siphon valve is usually placed in the...

The anti siphon valve is usually placed in the fuel line after it leaves the tank. Attached is an example of the part you need. You will need to make sure on hose size...
Forum: Electrical 07-26-2021, 01:57 PM
Replies: 5
Views: 1,589
Posted By Antibes
The larger black should connect negative...

The larger black should connect negative terminals. Can use threaded or friction connection. The small gauge wires are from the charger one to each threaded post. I don't see the larger positive...
Forum: General Interest 04-14-2021, 12:22 PM
Replies: 17
Views: 3,298
Posted By Antibes
I think beer and ice would be needed to ponder...

I think beer and ice would be needed to ponder any problems that could arise to smooth out troubleshooting
Forum: Troubleshooting 01-22-2021, 12:18 PM
Replies: 12
Views: 2,744
Posted By Antibes
I was having intermittent issues like that for...

I was having intermittent issues like that for about two years until I replaced the battery cables. No more loss of power at random times. The cables had degraded over the years and cleaning...
Forum: Troubleshooting 10-23-2020, 05:37 PM
Replies: 14
Views: 3,384
Posted By Antibes
As I understand it, once the black pipe is used...

As I understand it, once the black pipe is used any length of time the threaded connections will basically rust to seal. Making pipe sealant unnecessary. The flange and stainless connections might...
Forum: Introductions 08-26-2020, 11:08 PM
Replies: 23
Views: 8,235
Posted By Antibes
Check all connections in the fuel lines. Years...

Check all connections in the fuel lines. Years ago I was not leaking fuel out, but air in and she would die out after time
Forum: General Interest 08-16-2020, 12:40 PM
Replies: 1
Views: 1,558
Posted By Antibes
I think of this forum on days like that. I...

I think of this forum on days like that. I motor-sailed 10 hours without issue last Monday.
Forum: Fuel System 06-19-2018, 12:25 PM
Replies: 49
Views: 14,663
Posted By Antibes
I was doing my end of the year run, 21 miles and...

I was doing my end of the year run, 21 miles and the engine sputtered to a stop and would not restart until I got a tow in. It ran fine for a long time before dying out
Forum: Fuel System 06-18-2018, 03:47 PM
Replies: 49
Views: 14,663
Posted By Antibes
I had no fuel leaking out when air getting in...

I had no fuel leaking out when air getting in caused shutdowns
Forum: Fuel System 06-18-2018, 01:34 PM
Replies: 49
Views: 14,663
Posted By Antibes
Have you checked all the fuel connections. If...

Have you checked all the fuel connections. If they are loose or too tight on the hoses, air can get in and cause stall out.
Forum: Troubleshooting 06-07-2018, 12:31 PM
Replies: 17
Views: 4,724
Posted By Antibes
How long did it run before the shut down? Lake...

How long did it run before the shut down?
Lake Conditions?
Is there a water separator on the main filter?
When you say Just stops is that sudden or gradual?
Forum: Cooling System 05-16-2018, 12:12 PM
Replies: 56
Views: 27,641
Posted By Antibes
I think Marine clamps are one of those must do. ...

I think Marine clamps are one of those must do. Hose clamps failing underway is too scary to save a couple bucks. Remember two clamps per end
Forum: General Maintenance 10-20-2016, 03:28 PM
Replies: 22
Views: 6,658
Posted By Antibes
When I first saw my boat on the hard, it had...

When I first saw my boat on the hard, it had water almost to the settee cushions.

For the teak and mahogany I used teak cleaner and teak oil on it. The results were perfect. I impressed the...
Forum: Exhaust System 09-14-2016, 02:55 PM
Replies: 10
Views: 7,668
Posted By Antibes
The black pipe threads basically corrode...

The black pipe threads basically corrode themselves shut very quickly, why sealant is unnecessary.
Forum: Troubleshooting 05-28-2016, 12:02 PM
Replies: 16
Views: 7,294
Posted By Antibes
http://www.moyermarine.com/forums/showthread.php?t...

http://www.moyermarine.com/forums/showthread.php?t=254
Forum: General Maintenance 10-08-2015, 12:16 PM
Replies: 41
Views: 16,043
Posted By Antibes
Kevin: My boat is coming of the lake in the...

Kevin:

My boat is coming of the lake in the next two weeks, and I store it just the other side of railroad bridge on the Calumet. If you need anther set of eyes, I have done most of the...
Forum: Troubleshooting 07-23-2015, 12:13 PM
Replies: 12
Views: 4,914
Posted By Antibes
I had a defective pcv cause my rpms to jump...

I had a defective pcv cause my rpms to jump around.
Showing results 1 to 20 of 20

 
Forum Jump

All times are GMT -4. The time now is 03:34 AM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.


Universal® is a registered trademark of Westerbeke Corporation

Copyright © 2004-2024 Moyer Marine Inc.

All Rights Reserved