Return to the home page...

Go Back   Moyer Marine Atomic 4 Community - Home of the Afourians > Search Forums
Register FAQ Community Today's Posts Search

Showing results 1 to 9 of 9
Search took 0.01 seconds.
Search: Posts Made By: CRUX
Forum: Cooling System 01-14-2022, 07:34 PM
Replies: 6
Views: 2,330
Posted By CRUX
Cleaned up the scale and installed studs along...

Cleaned up the scale and installed studs along with a new side plate.
Forum: Cooling System 11-22-2021, 10:20 AM
Replies: 6
Views: 2,330
Posted By CRUX
Yea, for obvious cost savings, and the fact that...

Yea, for obvious cost savings, and the fact that there's plenty of thread left, I was hoping to use that kit over buying 4 of the kits with the backing plates.
Forum: Cooling System 11-21-2021, 12:02 PM
Replies: 6
Views: 2,330
Posted By CRUX
Another side plate leak

Hey all.

Removed the side plate to repair a leak that the PO let go for what looks like a long time.

One bolt head was disintegrated, but managed to get out the other 7 with the help of some...
Forum: Troubleshooting 04-19-2021, 07:40 AM
Replies: 7
Views: 2,099
Posted By CRUX
I'm not sure if it has any relevance, but I used...

I'm not sure if it has any relevance, but I used to have trouble starting a SECOND time as well. First cold start fired up first time everytime, second start I would have to open the throttle...
Forum: Troubleshooting 04-16-2021, 08:29 AM
Replies: 35
Views: 7,240
Posted By CRUX
Successfully finished the job yesterday and the...

Successfully finished the job yesterday and the engine is back installed! Running like a top. Splash date is May 8.

Very thankful for the amount of room in the C30's, couldn't imagine doing the...
Forum: Troubleshooting 03-01-2021, 10:10 AM
Replies: 35
Views: 7,240
Posted By CRUX
Un-related to the oil pan, I have some deep...

Un-related to the oil pan, I have some deep scaling on the on all sides of the water jacket side plate. So deep that I am definitely wary to start chipping away. The pictures don't do it justice.

...
Forum: Troubleshooting 02-13-2021, 11:15 AM
Replies: 35
Views: 7,240
Posted By CRUX
Found it! Seems to be sleeping through a small...

Found it! Seems to be sleeping through a small “crack” about an inch and a quarter long in the side of the pan under where the water pump is mounted. I guess the PO let a water pump leak for a bit...
Forum: Troubleshooting 02-12-2021, 01:20 PM
Replies: 35
Views: 7,240
Posted By CRUX
Yes that is too bad Mo! Could always use an extra...

Yes that is too bad Mo! Could always use an extra set of eyes.

There is oil still in the pan, and I have it blocked up on an incline close to how it sits on the motor mounts. I’ll try the heat...
Forum: Troubleshooting 09-13-2020, 05:57 PM
Replies: 15
Views: 2,542
Posted By CRUX
Identifying Carb issue?

Hi All,

My situation is as follows...

Engine starts first time-every time with full choke and 1/4 throttle when it's the first start of the day and the engine is cold. Runs perfectly.

If I...
Showing results 1 to 9 of 9

 
Forum Jump

All times are GMT -4. The time now is 07:14 AM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.


Universal® is a registered trademark of Westerbeke Corporation

Copyright © 2004-2024 Moyer Marine Inc.

All Rights Reserved