Return to the home page...

Go Back   Moyer Marine Atomic 4 Community - Home of the Afourians > Search Forums

Showing results 1 to 2 of 2
Search took 0.01 seconds.
Search: Posts Made By: JuniorAtomic
Forum: Overhaul 03-06-2022, 07:33 PM
Replies: 6
Views: 2,132
Posted By Al Schober
Best bet for the valves is to take them to a shop...

Best bet for the valves is to take them to a shop with a valve grinder.
The seats in the block are tough unless you have the engine out. Goodson has tools to do the seats in place....
Forum: Overhaul 03-06-2022, 08:41 AM
Replies: 6
Views: 2,132
Posted By Dave Neptune
Junior, yes the valves do get lapped on the seat...

Junior, yes the valves do get lapped on the seat for a good seal. However the seats if bad get re-cut with a "seat cutter" first and the valve get "ground round" by a valve grinding machine. After...
Showing results 1 to 2 of 2

 
Forum Jump

All times are GMT -4. The time now is 07:49 AM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.


Universal® is a registered trademark of Westerbeke Corporation

Copyright © 2004-2024 Moyer Marine Inc.

All Rights Reserved