Forum: Drive Train / Propellers
02-11-2023, 12:12 PM
|
Replies: 34
Views: 3,795
|
Forum: Drive Train / Propellers
11-08-2022, 07:35 PM
|
Replies: 34
Views: 3,795
Not sure why you're replacing all that stuff. ...
Not sure why you're replacing all that stuff. Does it need replacement?
Make sure whoever is doing the shaft has the coupling in hand so they can drill the shaft for the coupling set screws. They...
|
Forum: Exhaust System
06-21-2021, 07:27 AM
|
Replies: 0
Views: 975
An Exhausting Problem - Newsletter - MMI
Hello Forum members, please check out MMI's new newsletter dealing with the Exhaust System. Critical information!
To view the newsletter: Click Here (http://moyermarine.com/ttjune_2021/)
|
Forum: Troubleshooting
05-09-2021, 05:07 PM
|
Replies: 11
Views: 3,152
Thanks to everyone for your help with this!!
...
Thanks to everyone for your help with this!!
We finally found out what was wrong when we had a meltdown (with LOTS of smoke!) of an ignition wire which was being rubbed by the throttle control!!...
|
Forum: Exhaust System
04-28-2021, 09:53 PM
|
Replies: 9
Views: 2,348
Replacement is easy, just a stainless pipe...
Replacement is easy, just a stainless pipe nipple. Size to fit the hose, length to allow you to saw off the threaded ends.
Alternate is a rubber plug where the exhaust exits the transom. Shut...
|
Forum: Exhaust System
04-28-2021, 01:01 PM
|
Replies: 9
Views: 2,348
|
Forum: Exhaust System
04-28-2021, 12:57 PM
|
Replies: 9
Views: 2,348
Ah...that reminds me. Centek makes spun...
Ah...that reminds me. Centek makes spun fiberglass unions for this type of stuff. When I removed my flapper that Neil mentioned (because the pin broke and the flapper was not flapping) I used a...
|
Forum: Exhaust System
04-28-2021, 10:55 AM
|
Replies: 9
Views: 2,348
It there is slack in the hoses so you can pull...
It there is slack in the hoses so you can pull them together without too much tension, just look for a hose repair coupling (not plastic) with the correct inside diameter. That said, I would look at...
|
Forum: Exhaust System
04-27-2021, 10:56 PM
|
Replies: 9
Views: 2,348
Once upon a time, somewhere around the late...
Once upon a time, somewhere around the late 1960's, it was popular to put a gate valve in the exhaust line to protect against following seas. If a skipper found himself sailing in such conditions he...
|
Forum: Exhaust System
04-27-2021, 10:20 PM
|
Replies: 9
Views: 2,348
DDO, Get rid of that sucker. What are at the...
DDO, Get rid of that sucker. What are at the other ends of the hoses?
If you have never used it as a valve, you could simply put a type of union there. (close nipple or similar), but even a brass...
|
Forum: Troubleshooting
04-19-2021, 10:54 AM
|
Replies: 7
Views: 2,053
SOME CALL IT NOISE - I CALL IT MUSIC
Noise implies malfunction.
I like to listen to the engine sounds to detect any problems. A somewhat subconscious thing. Works anywhere on the boat.
ex TRUE GRIT
|
Forum: Troubleshooting
04-19-2021, 10:20 AM
|
Replies: 7
Views: 2,053
|
Forum: Troubleshooting
04-19-2021, 10:14 AM
|
Replies: 7
Views: 2,053
Easy starting when cold is a symptom of a...
Easy starting when cold is a symptom of a too-rich mixture. An updraft carb should require a couple of tries when cold EVEN WITH THE CHOKE.
The fact that you need to open the throttle wide when...
|
Forum: Troubleshooting
04-19-2021, 10:08 AM
|
Replies: 7
Views: 2,053
|
Forum: Troubleshooting
04-19-2021, 07:40 AM
|
Replies: 7
Views: 2,053
|
Forum: Troubleshooting
04-11-2021, 10:24 AM
|
Replies: 41
Views: 6,852
|
Forum: Troubleshooting
04-10-2021, 06:53 AM
|
Replies: 41
Views: 6,852
|
Forum: Troubleshooting
04-09-2021, 01:09 PM
|
Replies: 25
Views: 4,991
|
Forum: Troubleshooting
04-08-2021, 11:20 PM
|
Replies: 25
Views: 4,991
|
Forum: Troubleshooting
04-08-2021, 11:31 AM
|
Replies: 25
Views: 4,991
|
Forum: Troubleshooting
04-07-2021, 10:36 PM
|
Replies: 25
Views: 4,991
|
Forum: Troubleshooting
04-07-2021, 10:14 PM
|
Replies: 41
Views: 6,852
|
Forum: Troubleshooting
04-07-2021, 04:43 PM
|
Replies: 25
Views: 4,991
Kroil isn't as good as the acetone and ATF...so...
Kroil isn't as good as the acetone and ATF...so when you say tap, what do you mean. I'd drive the acetone down around it then get a punch and hammer...1/4 inch flat punch in center of valve and give...
|
Forum: Electrical
04-07-2021, 10:35 AM
|
Replies: 7
Views: 2,175
There is another possibility.
I used to...
There is another possibility.
I used to observe this exact type of behavior in my old Volkswagens. The problem turned out to be in the starter. The explanation is a bit long, so bear with me:...
|
Forum: Troubleshooting
04-05-2021, 01:19 PM
|
Replies: 6
Views: 1,691
My two cents. I would get just get the gasket...
My two cents. I would get just get the gasket from MMI. Gaskets really aren't that expensive and certain gaskets are just darn critical for operation and reliability. This is one of them.
I...
|