Return to the home page...
Moyer Marine Atomic 4 Community - Home of the Afourians
>
Search Forums
Search Results
User Name
Remember Me?
Password
Register
FAQ
Members List
Search
Today's Posts
Mark Forums Read
Showing results 1 to 5 of 5
Search took
0.01
seconds.
Search:
Posts Made By:
zellerj
Forum:
Overhaul
08-31-2018, 10:27 AM
Replies:
16
Exchanging Accessory Drive How-To Needed
Views:
5,595
Posted By
ndutton
Please check this statement. Studying the...
Please check this statement.
Studying the attached picture and Figure 1 on page 5-1 of your Moyer Manual you'll see the accessory drive gear meshes with an idler gear off of the crankshaft gear....
Forum:
Fuel System
03-09-2018, 01:14 PM
Replies:
44
Order a new carburetor or keep messing around ?
Views:
8,586
Posted By
JDK
No go, only a few sputters, I bet I have to stay...
No go, only a few sputters, I bet I have to stay stuck here another month cause it won't run at all without that proper carburetor scavenge tube to the manifold.....I cranked until I flooded it, I'll...
Forum:
General Maintenance
01-30-2018, 10:49 AM
Replies:
0
Easier Water Pump Mounting
Views:
2,206
Posted By
JOHN COOKSON
Easier Water Pump Mounting
I discovered something that makes mounting a water pump on the accessory drive a tad easier. It should be helpful in limited access situations. Thought I would pass it on.
Twist a four inch stud...
Forum:
Reversing Gear
07-30-2013, 10:12 PM
Replies:
12
gear cross shaft vibrates out of alignment
Views:
5,466
Posted By
taylor
Thanks Hanley, I checked and know exactly what...
Thanks Hanley, I checked and know exactly what you mean.
So that screw will hold the cross shaft (34) in place, but there is another issue, which is that the shift cable and its bracket will...
Forum:
Reversing Gear
07-30-2013, 09:12 PM
Replies:
12
gear cross shaft vibrates out of alignment
Views:
5,466
Posted By
hanleyclifford
If you look in your parts manual page 129 at the...
If you look in your parts manual page 129 at the exploded view of the shaft and the yoke it controls you will see a set screw (#32) which locks the yoke to the shaft so that it may not move.
Showing results 1 to 5 of 5
Forum Jump
User Control Panel
Private Messages
Subscriptions
Who's Online
Search Forums
Forums Home
Announcements
Introductions
Drawings and Schematics
Testing Protocols
Discussion Topics
General Interest
Polls
Helpful Videos
ABYC and USCG Standards
Troubleshooting
General Maintenance
Ignition System
Electrical
Fuel System
Cooling System
Reversing Gear
Exhaust System
Drive Train / Propellers
Overhaul
Safety
Aftermarket Kits and Accessories
Specialty Tools
Moyer Marine Pin-Up's
Good Guys
Links of Particular Interest
The Wish List
Owner Discussion Groups
Discussion Groups
Alberg
Bristol
C&C
Cal
Catalina
Columbia
Dyer Glamour Girl
Ericson
Grampian
Herreshoff
Irwin
Islander
Morgan
Newport
O'Day
Pearson
Ranger
Sabre
Tartan
Off-Topic
General Discussion (Off-Topic)
Boat Construction/Repair
Captain's Confession
Weather
Marine Electronics / Interfacing and Integration
iPad/Tablet/Laptop Applications on the Water
Classified Ads
For Sale - Engines and Engine Parts
For Sale - Other Items
Wanted to Buy - Engines and Engine Parts
Wanted to Buy - Other items
Tools wanted or offered to rent
All times are GMT -4. The time now is
10:20 PM
.
Moyer Marine Inc.
-
Archive
-
Top
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Universal® is a registered trademark of Westerbeke Corporation
Copyright © 2004-2024 Moyer Marine Inc.
All Rights Reserved