Return to the home page...

Go Back   Moyer Marine Atomic 4 Community - Home of the Afourians > Members List

edwardc edwardc is offline

Afourian MVP

Visitor Messages

Showing Visitor Messages 1 to 5 of 5
  1. ALMA
    11-21-2019 06:34 PM
    Hi Ed. I saw a post from 2010 that you were asking weather or not to remove Vee Drive before pulling engine. I saw the post with the idea of taking first pick through silverware locker. Please tell me what you think is best for removing the engine. The engine runs great BUT it uses a quart of oil in 3-4 HOURS... I don't see any way to check the cylanders- They had no ridge when I had the head off years ago.

    Are you STILL a fan of the aftermarket PCV valve?

    Could THAT be the source of my big oil consumption?


  2. Pgnorthatlantic
    06-17-2016 04:29 AM
    Thanks for the detailed info on the heat exchanger Ed!
  3. briancarlin2006
    04-24-2015 05:08 PM
    Thank you for posting your stainless steel hot section. It's perfect for my 1969' Pearson 35. What grade stainless steel did you use? 316 or...
  4. Beyent
    11-02-2014 10:29 AM
    I just bought a 1979 C&C 34 with an Atomic 4 engine. I have the Atomic 4 blue booklet and the C&C Owners's Manual. I decided to winterize my boat myself. I followed the procedure set out in paragraph 2 on page 4 of the Atomic 4 blue booklet. I drained the cylinder block. I was not able to figure out how to drain the water pump or the manifold or the exhaust sytem. Is it important that the water pump, the exhaust system and the manifold be drained. I understood everything in your post about winterizing without starting the engine except the parts dealing with "replace the empty housing" and "clamp off the by pass". What is the empty housing that I should replace and what is the by pass that I should clamp off. Also, how will I know if I have a "water lift muffler". My boat is not close to a water source so I can't run the engine. Any help will be very much appreciated.
  5. Persistence
    11-15-2011 09:18 AM
    I noticed you had visited my profile page. I'll spiff it up with some pix sometime soon and let you know. Thanks again for your thoughts on the 'rpm' post. Hopefully, I'll carve out some time in the next couple weeks to work on it. I've been helping put a new roof on the Clubhouse at our sailing club, 'Tsa La Gi Yacht Club'. (I have several pix of that project - haha). Dave

About Me

  • About edwardc
    Boat Name
    Dolce Vita
    Home Port
    Pasadena, MD
    Laurel, MD
    Software Engineer
    Sailing, Computers, Volleyball
  • Signature
    @(^.^)@ Ed
    1977 Pearson P-323 "Dolce Vita"
    with rebuilt Atomic-4


Total Posts
Visitor Messages
Total Thanks
General Information
  • Last Activity: Yesterday 02:20 PM
  • Join Date: 08-27-2009

All times are GMT -4. The time now is 09:08 AM.

Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2021, vBulletin Solutions, Inc.

Universal® is a registered trademark of Westerbeke Corporation

Copyright © 2004-2021 Moyer Marine Inc.

All Rights Reserved